Dishes; Favourites; Basic Settings - Bosch CSG7584 1 Series User Manual And Installation Instructions

Display Selection
Standby ¡ On for a limited time
screen ¡ On (this setting increases energy
consumption)
1
¡ Off
Clock ¡ Digital
¡ Analogue
Alignment ¡ Align the display horizontally and
vertically.
1
Factory setting (may vary according to model)
Tone Selection
1
Button tone ¡ On
¡ Off
Volume ¡ Levels 1, 2, 3
Signal tone ¡ Very short duration (once)
¡ Short duration (ap-
prox. 5 seconds)
¡ Medium duration
(approx. 10 seconds)
¡ Long duration (ap-
prox. 30 seconds)
1
Factory setting (may vary according to model)
Appliance set- Selection
tings
Fan run-on ¡ Minimum
time
¡ Recommended
¡ Long
¡ Very long
Pull-out system ¡ Not retrofitted (if shelf supports
and a single set of pull-out rails
are fitted)
¡ Retrofitted (if 2 or 3 sets of pull-
out rails are fitted)
Pull-out system ¡ Not retrofitted (if shelf supports
and a single set of pull-out rails
are fitted)
¡ Retrofitted (if 2 or 3 sets of pull-
out rails are fitted)
Lighting ¡ When cooking and when the door
is opened
¡ Only when the door is opened
¡ Always off
Water hard- ¡ 4 (very hard)
ness
¡ 3 (hard)
¡ 2 (medium)
¡ 1 (soft)
¡ 0 (softened)
1
Factory setting (may vary according to model)
Personalisa- Selection
tion
Brand logo ¡ Display
¡ Do not display
1
Factory setting (may vary according to model)
1
1
, 4 and 5
1
1
1
1
1
1
1
Personalisa- Selection
tion
Operation after ¡ Main menu
switch-on
¡ Types of heating
¡ Steam
¡ Dishes
¡ Favourites
Elapsed cook- ¡ Do not display
ing time
¡ Display
1
Regional ¡ All

dishes

¡ European dishes
¡ British dishes
1
Dishes ¡ All
¡ No pork
¡ Kosher only
Childproof ¡ Button lock only
lock
¡ Deactivated
Automatic ¡ off
rapid heating ¡ On
1
Factory setting (may vary according to model)
Factory set- Selection
tings
Factory set- ¡ Restore
tings
Info Display
Appliance in- Display technical information about
formation the appliance.
16.2 Changing the basic settings
Press "Basic settings" in the menu.
1.
Press the required basic settings area.
2.
Press the required basic setting.
3.
Press to select the required basic setting.
4.
a The change is applied directly for most basic set-
tings.
To change additional basic settings, use
5.
back and select a different basic setting.
To exit the basic settings, use
6.
main menu or switch off the appliance using
a The changes are saved.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
16.3 Setting the time
Press "Basic settings" in the menu.
1.
Press "Time".
2.
To set the time, press the hour display or the minute
3.
display.
a The selected value is marked in blue.
Use the setting ring to set the time.
4.
The minutes are counted in 5-minute increments.
‒
To set it to the precise minute, press and hold
the corresponding area in the setting ring for
around 1-2 seconds. The minutes are shown in
dots. Use the setting ring to set the minutes.
To exit the basic settings, use
5.
main menu or switch off the appliance using
a The time is saved.
Basic settings en
1
1
1
1
to go
to go back to the
to go back to the
⁠ .
⁠ .
25