Download Print this page

Sealey RS131.V5 Instructions Manual

Roadstart emergency power packs

Advertisement

Quick Links

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
Warning:
instruction
explosion risk
manual
1. safety
read and understand the general safety and operating instructions before use. the following information is intended to help you
keep the product in top working order.
note – the battery in this unit is a consumable item and its ability to accept charge will reduce over time. we will warranty it
against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
if the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. under these circumstances we will
not replace the battery even if it is less than one year old.
you can help prolong the life cycle of the battery by following a few simple guidelines.
plug in your new roadstart to the mains transformer and make an initiAl charge lasting 38 hours.
ensure the unit is fully charged before storage.
do not leave the roadstart for longer than 2 months without putting it on charge.
do not attempt to start a vehicle when the roadstart battery voltage is reduced to less than 7Volts.
do not drop or roughly handle the roadstart – this will break or disjoin the battery terminals rendering the battery useless and the
warranty void.
do not use any other charger, other than the one supplied, to recharge the battery.
Important: to reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
manufacturer of any equipment you intend to use in the vicinity of the battery. remember to review warning marks on all products and on
engines. Modern vehicles contain extensive electronic systems. Check with the vehicle manufacturer for any specific instructions regarding the
use of this type of equipment on each vehicle. no liability will be accepted for damage/injury where this product is not used in accordance with
all instructions.
1.1.
personaL precaUtIons

ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working
near a lead-acid battery.

Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.

Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool,

clean running water for at least 15 minutes and seek immediate medical attention.

remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit
current high enough to weld a ring or the like to metal, which may cause severe burns.
1.2.
Important safety InstrUctIons

familiarise yourself with the applications, limitations and potential hazards of the roadstart.

Keep the unit in good working order and condition. replace damaged parts immediately.

use only recommended parts. to use unapproved parts may be dangerous and will invalidate your warranty.
The RoadStart must only be opened and checked by qualified service personnel. do not disassemble the unit for any reason.


Keep children and unauthorised persons away from the work area.

Keep work area clean and tidy and free from unrelated materials. ensure that there is adequate lighting.
If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.


When not in use re-charge every two months.
do not smoke or allow a spark, or flame in the vicinity of the battery or engine.


do not drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.

do not use roadstart to recharge dry cell batteries that are commonly used with home appliances. these batteries may explode
and cause personal injury and damage to property.

do not charge or boost a frozen battery.

do not use attachments other than those recommended. to do so may risk damage to the unit and other equipment and
possible personal injury.

do not pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.
do not operate in vicinity of flammable liquids or gases.


do not recharge the unit with plugs, cables or attachments that are damaged. replace such items immediately.

do not use this product to perform a task for which it is not designed.

do not store the unit in damp or wet locations or where the temperature may exceed 50°c.
© Jack sealey limited
instructions for
roadstart emergency power packs
model no's:
Warning:
Wear eye
corrosive
protection
substance
Important warranty InformatIon: keep yoUr roadstart HeaLtHy
Original Language Version
rs131.V5, rs132.V3
Wear
Warning:
protective
electricity
Gloves
rs131.V5 rs132.V3 | issue 2 (H) 11/01/18
protect
use in
Keep away
from
Well
from sources
rain
Ventilated
Areas
battery could
of ignition:
explode

Advertisement

loading

Summary of Contents for Sealey RS131.V5

  • Page 1 IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2: Specification

    RCD with portable products that plug into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You can obtain a residual current device through your sealey dealer. You must read and understand instructions concerning electrical safety.
  • Page 3: Charging Instructions

    Ac supply. faILUre to foLLow tHese InstrUctIons may caUse damage and/or possIBLe InJUry and wILL InVaLIdate tHe warranty. Original Language Version © Jack sealey limited rs131.V5 rs132.V3 | issue 2 (H) 11/01/18...
  • Page 4: Operation

    To turn the worklight ON and OFF, see fig.1.5. If used on its own the light will operate for up to 40 hours on a fully charged battery. 6.6.1. turn off light when not required to conserve battery power. Original Language Version © Jack sealey limited rs131.V5 rs132.V3 | issue 2 (H) 11/01/18...
  • Page 5: Using The Compressor

    9.2.3. 9.2.4. 9.2.5. 9.2.6. 9.2.7. 9.2.8. 9.2.9. 9.2.10. 9.2.11. Original Language Version © Jack sealey limited rs131.V5 rs132.V3 | issue 2 (H) 11/01/18...
  • Page 6: 10. Troubleshooting

    11 screws which hold the casing together and pull the casings apart. disconnect the battery leads. under the Waste batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme.

This manual is also suitable for:

Rs132.v3