Trouble Shooting; Guarantee Conditions - Bosch Sensixx'x TDi90 Operating Instructions Manual

Trouble shooting

Problem
The iron does not
heat up.
Water drips out of
the soleplate when
using the "shot of
steam" function.
Steam does not
come out in
horizontal position.
Excessive dripping
or steaming.
The motor does not
work.
Smoke comes out
when connecting the
iron for the first time.
Deposits come out
through the holes in
the soleplate (10).
The appliance
makes a pumping
sound.
If none of the above solves the problem, get in touch with
an Authorised Technical Service.

Guarantee conditions

The terms of the guarantee for this appliance are in
accordance with that stated by our representative for the
country in which it is sold.
The details of these conditions can be obtained from
the retailer from whom the appliance was purchased.
The purchase receipt must be presented when making
any claims against the terms of this guarantee.
Probable cause
The "SensorSteam" function
has been activated. The iron
is set to stand-by.
You have pressed the shot
of steam button (6)
repeatedly without waiting
for 5 seconds between each
press.
Dry ironing steam mode has
been selected.
No proper closing of "clean"
button (11).
The iron is not in a
horizontal position.
This may be caused by the
lubrication of some of the
internal parts.
Traces of lime scale are
coming out of the steam
chamber.
Water is being pumped into
the steam chamber.
Solution
Grip the handle of the iron to
re-start it.
Wait 5 seconds between each
press of the shot of steam
button.
Set the steam control to "eco"
or "max" position.
Point the iron away from the
ironing area. Actuate a few
times the "clean" button.
Use the iron in a horizontal
position.
This is normal and will stop
after a few minutes.
Carry out a cleaning cycle (see
"Calc'n Clean function"
section).
This is normal.
11
BOS CH