Sealey PTB40506.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction gloves
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this locker.
‰
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the chest clean and tidy in accordance with good workshop practice.
9
DO NOT use the chest for any purpose other than that for which it is designed.
8
DO NOT step on the drawers.
8
DO NOT overload the chest.
8
DO NOT clean the chest with any solvents which may damage the surfaces or protective coating.
8
2. INTRODUCTION
Textured powder coat finish, both solvent and rust resistant. Ball bearing drawer slides provide superior performance and carry heavier loads,
double sets on large drawers. All drawers have full width sand blasted aluminium 'Lift & Latch' drawer pulls, making easy access while preventing
inadvertent opening when being moved. Non-slip drawer liners supplied for all drawers. Integral locking system locks all drawers with the turn of 1
key. Supplied with two keys. Hang-On chest suitable for heavy-duty Premier rollcabs.
3. SPECIFICATION
Model no. ......................................................... PTB40506.V2
Overall size (W x D x H) ..........................405 x 460 x 885mm
4. ASSEMBLY
Refer to fig.1 and Parts Diagram
NOTE: Heavy item - get assistance to assemble.
NOTE: Minimum height of the rollcab top edge is 15mm and
minimum depth of rollcab is 460mm.
4.1. TOOLS REQUIRED: 10mm socket, ratchet, crosshead
screwdriver.
4.2. INSTALL HANGER
4.2.1. Attach with countersink screw (3).
4.3. HANG CABINET fig.2
4.3.1. Fit protection pads (5).
4.3.2. Hang on the rollcab top.
fig.2
© Jack Sealey Limited
6 DRAWER HANG-ON CHEST - HEAVY DUTY
PTB40506.V2
MODEL NO:
fig.1
Original Language Version
ITEM DESCRIPTION
1 M6x16mm hex bolt
2 Connector
3 M6x16mm countersink screw
4 Hanger
5 EVA pad
6 Slide Set
7 Drawer liner
8 Lock
PTB40506.V2
QTY
3
1
4
1
2
7 sets
6
1
Issue 1 15/04/20