Dimm - Canon imagePRESS Server G200 Service Manual

4. Remove the printer interface board from the chassis.
Gently pull the printer interface board straight out of the PCIE x16 slot on the motherboard. Place the printer interface board on
an antistatic surface.
● To replace the printer interface board
1. Firmly seat the printer interface board in PCIE x16 on the motherboard.
For the location of PCIE x16 slot,, see
one way.
2. Replace the mounting screw that secures the printer interface board to the chassis.
Insert the mounting screw through the chassis and into the hole on the board mounting bracket (see
interface board" on page
3. Connect one end of the 10-pin power button cable to J351 connector on the printer interface board. Connect the other end
to the J11 connector on the motherboard.
The cable connector is keyed to fit only one way.
4. Reassemble the imagePRESS Server and verify its functionality (see
service" on page 34).

DIMM

DIMM (dual in-line memory module) is held in place by a lever at the end of DIMM-A0 slot. The motherboard contains two DIMM
slots, DIMM-A0 and DIMM-B0 (see
NOTE:
Approved DIMMs are available from your authorized service/support center.
■ To replace a DIMM
1. Access and open the imagePRESS Server, as described on
2. To release a DIMM, push outward on the levers on each side of the DIMM (see below figure).
No.
1 Lever
2 DIMM
3 Slot notch
3. Lift the DIMM straight out of the slot.
"Motherboard jumpers" on page
16). Tighten the screw completely.
"Motherboard jumpers" on page
1
19. The printer interface board is keyed to fit only
"Restoring imagePRESS Server functionality after
19).
"Accessing the imagePRESS Server" on page
2
3
Releasing a DIMM
Item
17
3. REPLACING PARTS
"To remove the printer
13.
1