Table of Contents
Advertisement
How to Affix the Ferrite
Core
Ferrite core may not be provided depending on each
nation' s regulations.
Affix the Ferrite Core for power
cord
You must affix a ferrite core in order to reduce or
eliminate electrical interference.
1. Pull the stopper [a] of the ferrite core to open.
2. Wind the power cord around the ferrite core
once.
3. Close the ferrite core until it clicks.
,
Note
y If there is a strong electromagnetic wave
product nearby, interference may occur. Put
the unit (Wireless Receiver and main unit)
away from there.
y If there is no audio signal for longer than
10 minutes, the Wireless Receiver will
automatically switch to standby mode. In
power saving mode, both LEDs will turn red.
LEDs will turn blue or yellow when there is
any audio signal back.
y If you operate main unit then wireless
speakers (rear speakers) sound within a few
seconds in standby mode.
y Set the distance between this unit and
Wireless Receiver within 10 m (32 ft.).
y Optimum performance can be implemented
only when the Wireless TX and the Wireless
Receiver within distance of 2 m (6 ft.) to 10
m (32 ft.) is used since communication failure
may occur if longer distance is used.
y Be sure to match the speaker cable to the
appropriate terminal on the components: +
to + and – to –. If the cables are reversed, the
sound will be distorted and will lack bass.
y It takes a few seconds (and may take longer)
for the Wireless TX and Wireless Receiver to
communicate with each other.
y Use the rear speaker at least 30 cm (11 inch)
away from either TV screen or PC monitor.
Connecting
17
2
Advertisement
Table of Contents
