Table of Contents
Advertisement
Image Stabilizer
The Image Stabilizer cannot compensate for a blurred shot caused by a subject that moved.
O
O
The Image Stabilizer might not be fully effective in the following conditions:
O
O
• Large shake or fast vibration
• Panning in MODE 1
If using a camera that allows you to change the shutter mode setting, [Elec. 1st-curtain] or [Electronic]
O
O
settings is recommended* to allow the Image Stabilizer to be fully effective.
* When using an EOS R camera, select either [Mode 1] (default factory setting) or [Mode 2] in the [Silent LV
shoot.] settings, or select [Enable] in the [Silent shutter] settings.
Vibration such as during transport may unlock the Image Stabilizer and cause rattling, but this is not
O
O
breakage and will have no effect on usage. This will be rectified once the lens has been mounted on the
camera.
When using a tripod, the Image Stabilizer might not be fully effective or it might be better to set the
O
O
STABILIZER switch to OFF, depending on the type of tripod and where the tripod is located, as well as on
the camera's settings such as shutter speed.
Although image stabilization will operate when using a monopod, depending on the shooting conditions,
O
O
sometimes the Image Stabilizer might not be fully effective.
When movie recording, operation of the Image Stabilizer will differ.
O
O
• For cameras with in-body Image Stabilizer, vibrations are corrected in all directions, regardless of the
Image Stabilizer mode selected.
• For cameras without in-body Image Stabilizer, the Image Stabilizer will not work when the Image Stabilizer
mode is set to MODE 3.
ENG-16
Advertisement
Table of Contents
