Page 1
Automatic washing machine WMA 647 W WMA 647 S WMA 657 W WMA 657 S WMA 667 W WMA 667 S Get other manuals https://www.bkmanuals.com...
Page 2
Please read this manual first! Dear Customer, We hope that your product which has been manufactured in modern facilities and passed through a strict quality control procedure will give you the best results. Therefore, we advise you to read through this manual carefully before using your product and keep it for future reference.
TABLE OF CONTENTS 1 Your Washing Machine Program selection and consumption table Overview Auxiliary functions Specifications Time screen Starting the program 2 Warnings Progress of program. General Safety Changing the selections after the First Use program has started Intended use Child-proof lock Safety instructions Cancelling the program If there are children in your house...
Specifications Models Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net Weight (kg) Electricity (V/Hz.) 230 V / 50hz Total Current (A) Total Power (W) 2200 2200 2200 2200 2200 2200 Spinning cycle (rpm max.) 1400 1400 1500 1500 1600 1600 Specifications of this appliance may change without notice to improve the quality of the product.
Warnings Please read the following information. for 3 seconds to cancel the program Otherwise, there may be the risk of set in your machine before calling personal injury or material damage. the authorized service. Moreover, any warranty and reliability First Use commitment will become void. • To prepare your machine for General Safety washing, carry out your first washing • Never place your machine on a process without loading your carpet covered floor. Otherwise, lack...
remain in an undamaged state. Electrical connection • Fit the draining hose to a washbasin Make sure that you have an earthed or waste system securely before power outlet socket rated at 13 amps starting up your machine. There may (minimum). be a risk of being scalded due to Attention! high washing temperatures! If you use your machine as built-in, • Never open the door or remove the the socket must be reachable after...
Page 8
cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.
Installation Removing packaging 3. Fit the covers (supplied in the bag reinforcement with the Operation Manual) into the Tilt the machine to remove the holes on the rear panel. (“P”) packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. C Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.
must be attached to the machine. Tighten the nuts of the hose well by hand; never use wrenches to tighten the nuts. 2. Adjust them until the machine stands level and firm. 3. Important: Tighten all lock nuts up again. Connecting to the water supply. Important: • Open the taps completely after • The water supply pressure required making the hose connection to to run the machine must be 1-10 check if there is any water leakage...
Your house may be flooded if the Electrical connection hose falls out of its housing during Connect the machine to an earthed water discharging. outlet protected by a fuse of suitable • The hose should be attached to a capacity. height of at least 40 cm, and 100 Important: cm at most. • Connection should comply with national regulations.
Initial preparations for washing Sorting the laundry • Empty pockets and remove all foreign objects such as coins, pens • Sort the laundry according to type and paper clips. If possible, turn of fabric, color, and degree of soiling pockets out and brush. and permissible water temperature. • Place small items like infants’ Always follow the advice on the socks and nylon stockings, etc.
Following weights are given as examples. Detergent, softener and other cleaning agents Laundry type Weight (gr.) Add detergent and softener before Bathrobe 1200 starting the washing program. Napkin Never open the detergent dispenser Duvet cover drawer while the washing program is Bed Sheet running! When using a program without pre-...
Page 14
follow the instructions on the Detergent package. quantity for prewashing 1/2 measure for main 1 measure washing an additional with hard water 1/2 measure Softener Put the softener into the softener compartment of the detergent dispenser. • Use the proportions recommended on the packet. • Never exceed the (> max <) level marking; otherwise, the softener will be wasted without being used. • If the softener has lost its fluidity, dilute dense softener with water before placing it in the detergent...
Selecting a program and operating your machine Control panel Figure 2 7 – Spin Speed Adjustment Button 8 - Time Delaying Button (+/-) 9 - Temperature Adjustment Button 10 - Start/Pause/Cancel Button 11 - Auxiliary Function Buttons a- Prewash b- Quick Wash c- Rinse Plus d- Anti-creasing 12 - Program Selection Knob 13 - Display 14 - On / Off Button Get other manuals https://www.bkmanuals.com...
Display symbols Figure 3 appear. Press “Start/Pause/Cancel” button (Figure 2-10) to start the program. Main programs Depending on the type of textile, the following main programs are available: •Cottons 13.a - Spin Speed Indicator You can wash your durable clothes 13.b – Temperature Indicator at this program. Your laundry shall 13.c – Spinning Symbol be washed with intense washing 13.d – Temperature Symbol movements during a longer washing 13.e – Remaining Time and Delaying cycle. It is recommended for your Time Indicator cotton clothes (such as bed sheets, 13.f – Program Indicator Symbols...
is recommended at this program. It which you cannot use the “Cotton 60°C” washes the laundry with very tender program. washing movements without wearing Each of these main programs comprise your clothes out. of a complete washing process, •Woollens including washing, rinsing and, if You can wash your machine-washable required, spin cycles. woollen garments at this program.
program appears on the temperature Rinse hold is shown with “ ” and no indicator (13b). spin is shown with “ ” symbols. To change the temperature, press the temperature button (Figure 2-9). Temperature falls with 10° decrements. Cold selection is shown with “-” symbol. If you do not want to unload your clothes immediately after the program, you may use the rinse hold function in When the “Temperature” button is order to prevent your clothes become...
Auxiliary functions Quick wash With this program (11b), the wash time Auxiliary function selection keys is shortened. “F2” symbol will light up on the display. • Use this function for smaller amounts or slightly soiled laundries. Extra rinse This function (11c) allows your machine to perform an extra rinsing in addition to the rinsing cycles performed by your machine after main washing cycle. Thus, the risk for sensitive skins (babies, allergic skins and etc.) to be effected by the minimal detergent remnants on the...
Time delay time delay will start flashing. With the “Time delay” function you can delay the program start up to 24 hours. Cancelling the time delay Setting can be made in intervals of 30 If you want to cancel the time delay minutes. countdown and start the program 1. Open the loading door, place the immediately: 1. Press “Start/Pause/Cancel” button...
indicate the beginning of prewash step. Adding/taking out laundry in standby Main wash mode Main wash symbol will light up to The door can be opened if the water indicate that the main wash cycle has level is suitable. The door locked symbol started. (Figure 3-13i) will light up until the door Rinse is suitable for opening.
Program in rinse hold mode This process is shown with the • flashing Spin Symbol (Figure 3-13c) and the lit up Standby Symbol (Figure 3-13k). If you wish to spin when the machine is in this mode: Adjust the spin speed. Press “Start/ Pause/Cancel” button (Figure 2-10). The program continues, pumps out the water and spins. Standby Symbol (Figure 3-13k) fades out and Start Symbol (Figure 3-13j) lights up.
Quick instructions for daily use Preparation adding more laundry during a future 1. Turn the tap on completely. Check if step only if the water level is low the hoses are connected tightly. enough to open the loading door or 2. Place the laundry in the machine.
Page 25
After the program is finished Program indicator symbols (Figure 3-13f) on the screen will remain lit after the program is finished. “End” will appear on the screen. 1. Open the loading door and take out the laundry when the door locked symbol on the display (Figure 3-13i) fades out. 2. Press the “On/Off” button (Figure 2-14). 3. Turn the water tap off. 4. Remove any folds in the rubber seal on the loading door and check for debris.
Cleaning and care Detergent drawer • Open the hole in the bellow with the aid of a toothpick if it is clogged. Remove any powder residue buildup in the drawer. To do this; C Foreign metal substances in your 1. Press the dotted point on the machine can cause rust stains. In siphon in the softener compartment such cases: and pull towards you until the Clean the drum with a stainless steel...
• If the filters are very dirty, you can pull them out by means of pliers and clean them. • Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under streaming water. • Replace the gaskets and filters carefully and tighten the hose nuts by hand. Draining any remaining water and cleaning the pump filter Filter system in your machine prevents...
Page 28
If your product is not supplied with an emergency drain hose, do the following as shown in the figure below: • Place a large container in front of the filter to receive water flowing from the filter. • Loosen pump filter (anticlockwise) until water starts to flow out of it. Direct the flowing water into the container you have placed in front of the filter. You can use a piece of cloth to absorb any spilled water.
Troubleshooting Problem Cause Explanation / Suggestion Machine may have Program switched to self Reset your machine by pressing “Start/Pause/ cannot be protection mode due to Cancel” button for 3 seconds. (see, Cancelling started or an infrastructure problem a Program) selected. (such as line voltage, water pressure, etc.). There may be some water in your machine when you Water in the receive it.
Page 30
The water being taken Improper position of the Connect the water draining hose as described in is directly drain hose. in the operation manual. discharged. No water can This is not a problem. The be seen in water level is not visible the machine from the outside of the during...
Page 31
In the case of a paused countdown while taking in The machine will wait until there is a sufficient water: amount of water to avoid poor washing results Timer will not countdown due to lack of water. Then the timer will start to until the machine is filled count down.
Page 32
- Using insufficient amount of detergent for a long time, - Use the recommended amount of detergent - Washing at low appropriate for water hardness and the laundry. Washing temperatures for a long - Select the proper temperature for the laundry performance is time, to be washed.
Page 33
The amount, brand and storage conditions of the Store detergent in a closed and dry place. Do detergent used might not not keep them under high temperatures. be appropriate. If detergent is put in the prewash compartment Detergent might have although prewash cycle is not selected, the been put in the wrong machine can take this detergent during rinsing...
Page 34
Detergent may have been Dry the detergent drawer before putting in put in wet dispenser detergent. drawer. Detergent may have Store detergent in a closed and dry place. Do gotten damp. not keep them under high temperatures. Detergent Water pressure might be residue in the dispensing The detergent in the main...
Should you experience any difficulty in You should also complete the details obtaining service please contact the below; it will help us assist you when Beko Customer Help-Line. requesting service. (The model number Tel: 0845 600 4911 is printed on the Instruction Booklet e-mail:service@beko.co.uk and the serial number is printed on the Rating Label affixed to the appliance)
Page 36
Get other manuals https://www.bkmanuals.com...