Adjustable Backsplash - Sharp KB-3411JK Install Manual

INSTALLATION MANUAL

ADJUSTABLE BACKSPLASH

The range backsplash is adjustable so that you can customize it
for your particular kitchen situation. The height can be adjusted
from the low position (6-inches high) to the highest position
(12-inches high) in one inch increments.
Remove the screws from the
1
cooktop back frame end cap
on both sides and the screws
from the range back cover
on both sides, as shown
in Figure 12. The endcaps
and mounting screws may
be located near or inside
backsplash accessory pack.
Note: Set screws to the side
to use for mounting the
backsplash. The two back
cover screws must be placed
back into the back cover.
2 Slide the rubber gasket onto the back edge of the cooktop back
frame as shown in Figure 13.
Figure 13
3 Carefully pull each end cap back slightly—no more than
1/8-inch—to facilitate installing the backsplash.
Figure 12
IMPORTANT
This backsplash must be installed before the range is moved
into place.
Slide the backsplash in to desired height. Secure into position
4
with screws supplied and those removed in step 1.
(Total 4 each side)
Figure 14
Place the backsplash support brace into the back side of the
5
backsplash. Angle as shown to insert, slide downward to rest
on top of the end cap screws.
6