JVC CV532PJ Instruction Manual page 4

surfaces likely to be contacted by the patient or an attendant who can touch the
patient. This encloses a space within the room 1.83 m (6 feet) beyond the perimeter of
the bed in its intended location, and extending vertically 2.29 m (7–1/ 2 feet) above the
floor.
Equipment Classification
● Type of protection against electric shock: Class I equipment
● Protection against harmful ingress of water: Ordinary Equipment (IPX0)-No protection.
● Mode of operation: Continuous operation
Erp Information for the external power supply
Information
published
Manufacturer's name
or trade mark
commercial
registration
number, address
Model identifier
Input voltage
Input AC frequency
Output voltage
Output current
Output power
Average active
efficiency
Value and
precision
Lite-On Technology
Corporation
22F., No.392, Ruei
Kuang Rd., Neihu Dist.,
Taipei City 114, Taiwan
PA-1061-81
100–240
50/60
12.00
5.00
60.00
88.71
- 4 -
Unit
-- --
-- --
-- --
V Specified by the manufacturer. Shall
be a value or a range.
Hz Specified by the manufacturer. Shall
be a value or a range.
V Nameplate output voltage. Shall
indicate whether is AC or DC. In
cases where more than one physical
output or more than one output
voltage at load condition 1 are
measured, the sets of available
Output voltage — Output current
– Output power shall be published.
A Nameplate output current. In cases
where more than one physical
output or more than one output
voltage at load condition 1 are
measured, the sets of available
Output voltage — Output current
– Output power shall be published.
W Nameplate output power. In cases
where more than one physical
output or more than one output
voltage at load condition 1 are
measured, the sets of available
Output voltage — Output current
– Output power shall be published.
% Declared by the manufacturer
based on the value cal-culated as
arithmetical mean of efficiency at
load con-ditions 1–4. In cases where
multiple average active efficiencies
are declared for multiple output
voltages available at load condition
1, the value published shall be the
average active efficiency declared
for the lowest output vol-tage.
Notes