will become ineffective as an anode.
1. Trim tab
2. Bolt
3. Cap
Bolt tightening torque:
40 Nm (4.08 kgf-m, 29.5 ft-lb)
A
B
ZMU01863
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
1. Tilt support lever
ECM00660
NOTICE
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
EMU26392
Cowling lock levers
To remove the outboard motor top cowling,
pull up the front and rear cowling lock levers.
Then lift off the cowling. When the cowling,
check to be sure it fits properly in the rubber
seal. Then lock the cowling again by moving
the cowling lock levers downward.
ECM00550
NOTICE
The air intake grille on the top cowling is
not designed as a handle and could break
if used as such.
Components
1
ZMU03979
25