Advertisement
Quick Links
Continuous Ink Supply System
Epson Stylus Photo 790
Installation Instruction
This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and
Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole
operation is very easy. It's really an effective tool to save your money.
for
For ST Prefilled Version
With Auto Reset Chips
Advertisement
Related Manuals for Epson Stylus Photo 790
Summary of Contents for Epson Stylus Photo 790
- Page 1 Continuous Ink Supply System Epson Stylus Photo 790 Installation Instruction For ST Prefilled Version With Auto Reset Chips This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole...
-
Page 2: General Guide
CIS for EPSON Stylus Photo 790 Instruction Thank you for purchasing ST Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed ST Continuous Ink Supply system on your own printer. -
Page 3: Installation Procedures
3、Installation Procedures: 1) First step Put the CISS on the left side Pull out the small rubber plug Place 6pcs of air filters into of the printer. In the meantime from the air hole as above air holes, the thicker side place all the tubes at correct picture shown. - Page 4 4) Fourth step: Fix Support Arm Tear off the sticker Fix the arm on the 8cm right far from Tear off the sticker you printer Fix the balance arm Tear off the sticker of clamp Attached the clamp on your printer and let it parallel with printer 5) Fiveth step : Install tubeline Insert tubelline through the arm...
-
Page 5: Reset Procedure
Too long twist Perfect 7)Seventh step Instert the plug Turn on the power switch check wether all thing is usual 8)Eighth step: Nozzle check Usual Broken line If appear like this,pls clean priner head The nozzle check patterns are in broken-line, mostly because of small dusk entered into the nozzle, after repeated cleaning, if there is still a few broken line, pls let the printer don’t work about 1 hour, then print the nozzle check pattern, maybe it works well. - Page 6 If the indicator light flashing when printing, it tells that you need to reset the chip to full status. Please turn off your printer for about 30 seconds and switch it back on. Ink meter bar shall show full ink. You can start printing as usual. 5、Refill Ink: Please pay attention to the ink level in the reservoirs;...
- Page 7 closed tightly during the transportation. Otherwise, the ink shall leak out. 6. Don’t sway the cartridge frequently. It may cause ink leakage. 7. Don’t pull out the connector of cartridge and don’t tear off adhesive tape at the bottom of cartridge. Warning: 1.