Table of Contents
Advertisement
CAUTION!
Some models are fitted with
a silencing pad under the
cabinet. Do not remove this
pad.
3
8.5 Rear spacers
Install the two spacers and the locking
pins provided within the accessory bag
as shown in the figure.
8.6 Connecting the water hose
WARNING!
Always use a safety valve in
the water connection.
Water supply should be provided with a
tap and 3/4" male connector within 1,5 m
from the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
If the appliance has been purchased
together with the corresponding fridge
the installation should be conducted in
such a way that both appliances share
the safety valve supplied with the fridge.
If this appliance has been purchased as a
single installation or together with an
appliance without water connection, a
safety valve (1504516-00/4) must be
installed. This item can be ordered via
www.electrolux.com
Before the appliance is placed in final
location, ensure that the water
connection has been correctly carried
out and that there is no leakage at the
2
connection to the water tap.
Tighten the screw enough by hand.
Make sure that the gasket is properly
positioned in the connector.
We recommend that the appliance is
placed on a "run-off" mat intended for
refrigerators and freezers, which makes it
easier to detect possible leakage.
8.7 Levelling
When placing the appliance ensure that
it stands level. If necessary adjust the feet
using the adjustment spanner supplied.
Door alignment is dependent on proper
levelling.
8.8 Starting the ice maker for
the first time
Ensure proper connection to the water
supply, refer to "Connecting the water
hose".
It will start filling water when the
temperature is sufficiently low.
ENGLISH
17
Advertisement
Table of Contents
