Philips HR 7720/B Service Manual

Philips Domestic Appliances and Personal Care
PRODUCT INFORMATION
The food processor is equipped with mechanical and
thermal safety switches.
Motor power
Voltage
Cordset
Speed settings
Speed unloaded
Weight in fancy box
Dimensions (l x w x h)
Automatic resettable cut-out (part of item 7)
To prevent damage due to overheating, the
appliance has been equipped with an automatic cut-
out system.
If the appliance overheats, this system will
automatically cut off the power supply.
If the appliance suddenly stops running:
Unplug the appliance
−
Set the knob to position 0
−
Let the appliance cool down for 15 minutes
−
Plug the appliance in again
−
Switch the appliance on again.
−
Safety lock (item 1)
Place the lid on the bowl in the right position.
The appliance will only function if the arrow on the
motor unit is directly opposite the mark on the lid.
The built-in safety lock will now be deblocked and
you can turn the appliance on.
Published by Philips Domestic Appliances and Personal Care
4322 277 00094
99/12
PCS 101 299
Cucina
: 600 W
: 220-240 V ; 50-60 Hz
: 120 V ; 50-60 Hz
: 125 cm
: 2 speeds + pulse
: acc. drive shaft 2150 rpm
: 5400 g
: 410 x 273 x 305
Printed in the Netherlands
SERVICE INFORMATION
A separate drawing shows how to disconnect the
−
speed selection knob.
Top housing (item 35) can be removed by detaching
−
the snap connections by sticking a pin (or a
screwdriver) through the small round holes (3 mm
dia.) in the bottom plate (item 27) and the housing
(item 12). The arrows in the drawing show the
locations of the holes.
The accessory drive shaft (item 15) has a locking
−
piece (item 14).
The assembly of accessories depends on the national
−
version.
For specific versions, the component configuration
−
may differ from the one shown on the exploded view.
However, the actual components can be distinguished
by their code numbers.
Make sure that all functions, including the safety
−
devices, are working correctly after you have
completed the repair.
©
Copyright reserved
Food processor
HR 7720/B
Subject to modification