Motorola SYMBOL LS2208 Quick Start Manual

SYMBOL LS2208
Quick Start Guide
http://www.motorola.com/ls2208
See Product Reference Guide for more information
Miscellaneous Settings
Set Defaults
SET DEFAULTS
Carriage Return/Line Feed
SCAN OPTIONS
<DATA><SUFFIX>
ENTER
LED Indications
Off Green
Scanner is on and Bar code is successfully
ready to scan, decoded
or no power to scanner
Beeper Indications
Standard Use
Low/medium/hih beep Short medium beep
Power up Bar code decoded
High/low/high/low beep High/low beep
Successful parameter Correct programming
setting sequence performed
NOTE: Cables may vary depending on configuration.
Step 1
Step 2 - Connect to Host
RS-232
Step 3 - Scan ONE of the following
STANDARD RS-232
ICL RS-232
NIXDORF RS-232 MODE A
NIXDORF RS-232 MODE B
FUJITSU RS-232
OPOS/JPOS
Accessories
Red IntelliStand
Transmission error
4 long low beeps
Transmition error detected,
data is ignored
Low/High beep
Incorrect programming
sequence or 'Cancel'
bar code scanned
- Cord Attachment/Removal
USB
Step 3
HID KEYBOARD EMULATION
IBM HAND-HELD USB
Keyboard Wedge
Step 3
IBM PC/AT and IBM PC COMPATIBLE
IBM 46XX
Step 3
- Scan ONE of the following
PORT 5B
PORT 9B
Wand Emulation
Step 3
SYMBOL WAND
- Scan the following
ENABLE CONVERT TO CODE 39
DISABLE CONVERT TO CODE 39
Troubleshooting
Scanner not working
No power to scanner Incorrect interface
cable used
Check system power; Ensure that correct
ensure power supply, interface cable is used
if required, is connected
Scanner decoding bar code, but data not transmitting to host
Scanner not programmed for correct host interface
Scan appropriate host
parameter bar codes
Scanned data incorrectly displayed on host
Scanner not programmed for correct host interface
Scan appropriate host
parameter bar codes
Scanner not decoding bar code
Scanner not programmed Bar code unreadable
for bar code type
Ensure bar code not defaced;
Ensure scanner is programmed
to read type of bar code try scanning test bar code of
being scanned same bar code type
- Scan ONE of the following
- Scan ONE of the following
Interface/power cables
are loose
Ensure all cable connections
are secure
Interface cable is loose
Ensure all cable connections
are secure
Distance between scanner
and bar code incorrect
Move scanner closer to
or further from bar code