Toro 22522 Operator's Manual
Toro 22522 Operator's Manual

Toro 22522 Operator's Manual

Standard bucket with spacer, compact tool carrier

Advertisement

Quick Links

Register at www.Toro.com.
Original Instructions (EN)
Standard Bucket with Spacer
Compact Tool Carrier
Model No. 22522—Serial No. 401000000 and Up
Form No. 3431-539 Rev A
*3431-539* A

Advertisement

Table of Contents
loading

Summary of Contents for Toro 22522

  • Page 1 Form No. 3431-539 Rev A Standard Bucket with Spacer Compact Tool Carrier Model No. 22522—Serial No. 401000000 and Up *3431-539* A Register at www.Toro.com. Original Instructions (EN)
  • Page 2 1. Model and serial number location The bucket is a load-bearing attachment intended to be used on a Toro tool carrier. It is designed primarily for moving rock, dirt, sand, or other materials. Using this product for purposes other than its intended use Model No.
  • Page 3: Table Of Contents

    Contents Safety Safety ............... 3 DANGER General Safety ........... 3 Slope Safety ............3 There may be buried utility lines in the work Bucket Safety ............. 4 area. Digging into them may cause a shock Maintenance and Storage Safety......4 or an explosion.
  • Page 4: Bucket Safety

    Bucket Safety load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing • Wear gloves, eye protection, long pants, attachment makes the front of the machine the substantial slip-resistant footwear, and hearing heavy end. Most other attachments make the front protection during operation or while adjusting or of machine the heavy end.
  • Page 5: Safety And Instructional Decals

    1. Tipping hazard—read the Operator's Manual; do not exceed To ensure optimum performance and continued safety loads of 204 kg (450 lbs). certification of the machine, use only genuine Toro replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be dangerous, and such use could void the product warranty.
  • Page 6: Operation

    Operation Material Density Material Density (Approximate) Determine the left and right sides of the machine from Caliche 1250 kg/m (78 lb/ft the normal operating position. Clay: Natural bed 1600 kg/m (104 lb/ft Installing and Removing 1480 kg/m (93 lb/ft the Attachment 1660 kg/m (104 lb/ft With gravel, dry...
  • Page 7: Transport Position

    Storage Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. Store the attachment in a clean, dry garage or storage area.
  • Page 8 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.

Table of Contents