Table of Contents
Advertisement
Available languages
Available languages
Control Cable
As a result of both the control cable and the auger drive belt stretching due to
wear, periodic adjustments may be necessary. If the auger seems to hesitate when
rotating, proceed as follows:
1.
The upper hole in the control handle provides for an adjustment in cable
tension. To adjust, disconnect the end of control cable from the bottom hole
in the control handle and reinsert it in the upper hole. Insert the cable from
the outside as shown in Figure 15.
Control Handle
Control Cable
2.
Test the snow thrower to see if there is a noticeable difference. If after the
adjustment to the control cable the auger still hesitates when rotating, see
Belt Replacement for instructions on replacing the belt.
Chute Assembly
Refer to the Assembly section for instructions on adjusting the chute assembly.
SERVICE AND MAINTENANCE
Figure 15
Auger Drive Belt Replacement
1.
Run the snow thrower until the fuel tank is empty.
2.
Pull the recoil starter handle until resistance is felt. Then tip the snow
thrower back until it rests on the handles.
3.
Slide a board up through the auger and through the chute to secure the
auger in place.
4.
Remove the belt cover by removing the two hex washer screws and one hex
lock screw that secure it to the frame. See Figure 16.
Hex Washer Screw
5.
Remove the flange nut that secures the auger pulley to the auger shaft. See
Figure 17.
Auger Shaft
Auger Pulley
6.
Remove the auger pulley and the belt.
15
Hex Lock Screw
Figure 16
Flange Nut
Figure 17
Advertisement
Chapters
Table of Contents
