Page 1
EPSON Stylus Pro 4000 ® Start Here Start Here Unpack Make sure you have all the parts shown below for your EPSON Stylus Pro 4000: Paper tray Printer Power cord Ink cartridges Roll paper spindle Exhaust port cover Spindle adapters (attached to spindle) The printer weighs about 85 pounds, and should be lifted by two people.
Install Ink Use the ink cartridges that came with your printer for initial ink charging. During the initial installation process, it is normal for up to one-third of the ink in each cartridge to be used. Press the Power button to turn on the printer. Power button Press both ink compartment covers to open them.
Page 3
Load Roll Paper Slide the black paper stop off the end of the spindle. If the paper has a 2-inch core, remove the adapters by pressing the four tabs. Make sure your hands are clean, and avoid touching the printable surface of the paper. Note: Try to handle paper by the edges.
Page 4
Load Cut Sheet Paper When you are ready to print on cut sheet paper, make sure you release the paper lever and wind up the roll paper. Then return the paper lever to the secured position and close the roll paper cover.
® ® Macintosh Turn on your Macintosh and your printer. Insert the printer software CD-ROM. If necessary, double-click the EPSON CD-ROM to open its window. Double-click the EPSON OS X Installer. If you are using Mac OS 9, double-click the EPSON OS 9 Installer.
Unit ID number. If you have any difficulty with this service, call (562) 276-1305. EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON CORPORATION. EPSON Preferred is a service mark of Epson America, Inc. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners.