Setup; Installing The Bar And Chain - Toro Flex-Force Power System 60V Manual

Setup

Important:
The battery pack is not fully charged when it is purchased. Before using the machine for
the first time, refer to your battery pack and charger Operator's Manual.

Installing the Bar and Chain

DANGER
Contact with the pole saw teeth can cause serious personal injury.
• Remove the battery pack before adjusting or maintaining the pole saw.
• Always wear gloves when adjusting or maintaining the pole saw.
1. Place the pole saw on a flat surface and do not install the battery pack.
2. Remove the side cover; turn the bar cover knob counterclockwise until the knob is removed and then
remove the side cover
1. Bar cover knob
2. Side cover
3. Chain
4. Chain adjusting stud slot
3. Place the chain around the sprocket on the front end of the guide bar, with the cutting edge of the chain
teeth on the top of the bar facing forward as shown in the diagram beneath the side cover of the pole saw.
4. Continue to feed the chain around the guide bar and align the chain into the groove of the guide bar.
5. Position the open loop of the chain (the side not on the guide bar) around the drive sprocket on the pole
saw (Figure 3).
Important:
Ensure that the chain adjusting stud is inserted into the chain adjusting stud slot
on the guide bar
You may need to rotate the chain-tensioning screw to fit the stud into the slot on the guide bar
(Figure 19).
6. Install the side cover and bar cover knob and loosely tighten the side cover by turning the knob clockwise.
7. Adjust the chain tension; refer to
(Figure 3).
5. Guide bar slot
6. Guide bar
7. Drive sprocket
8. Guide bar stud
(Figure 3).
Adjusting the Chain Tension (page
Figure 3
10
9. Oil outlet
10. Chain adjusting stud
19).
g374226