Package Contents; Electrical Safety; Assembly And Adjustments - DeWalt XR DCR016 Original Instructions Manual

EN GLI SH
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4° C and 40° C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack.
Charges Li-Ion battery packs.
See Technical Data for charging time.

Package Contents

The package contains:
1 Radio
1 Instruction manual
1 Exploded drawing
• Check for damage to the radio, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1–3)
WARNING: Never modify the radio or
any part of it. Damage or personal injury
could result.
a. Power button
b. Volume dial
c. Arrow buttons
d. Mode button
e. Clock button
f. Memory buttons
g. EQ button
h. LCD display
i. Battery compartment latch
j. Battery receptacle
k. Auxiliary port
l. Coin cell battery door
26
m. Coin cell battery
n. Battery pack
o. Fuel gauge

Electrical Safety

Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
WARNING: Risk of electric shock. Use
in dry locations only.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

Inserting a Battery Pack (fi g. 1, 3)
WARNING: Use only D
packs and chargers.
NOTE: Make sure your battery pack is fully charged.
If the battery pack does not produce sufficient
power, charge the battery pack following the
instructions in the manual of the charger.
NOTE: To ensure maximum performance and life of
Li-Ion batteries, charge the battery for a minimum of
10 hours before first use.
WALT battery
E