Related Manuals for Toro 31853
Summary of Contents for Toro 31853
- Page 1 Form No. 3460-977 Rev A Flex-Force Power System ™ MAX Snowthrower Model No. 31853—Serial No. 400000000 and Up Model No. 31853T—Serial No. 414300000 and Up *3460-977* Register at www.Toro.com. Original Instructions (EN)
- Page 2 Whenever you need service, genuine Toro parts, or For assistance, please see additional information, contact an Authorized Service www.Toro.com/support Dealer or Toro Customer Service and have the model for instructional videos or and serial numbers of your product ready. Figure 1...
-
Page 3: Safety Alert Symbol
Safety-Alert Symbol Safety The safety-alert symbol (Figure 2) shown in this IMPORTANT SAFETY manual and on the machine identifies important safety messages that you must follow to prevent accidents. INSTRUCTIONS WARNING g000502 When using an electric machine, always Figure 2 read and follow basic safety warnings and Safety-alert symbol instructions to reduce the risk of fire, electric... - Page 4 Prevent unintentional starting—Ensure that could throw. the electric-start button is removed from the Use only the battery pack specified by Toro. machine before connecting the battery pack and Using other accessories and attachments may handling the machine.
- Page 5 • Replace the battery pack with a genuine Toro battery pack only; using another type of When the battery pack is not in use, keep it battery pack may cause a fire or risk of injury.
-
Page 6: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal137-2257 137-2257 1. Warning—read the Operator’s Manual. 3. Thrown object hazard—keep bystanders away. 2. - Page 7 decal137-9461 137-9461 1. Battery charge status decal140-8490 140-8490 1. Keep away from open fire 4. Recycle the battery or flames. properly. 2. Do not expose to rain. 5. Contains lithium ions; do not dispose improperly. decal115-5660 115-5660 3. Read the Operator’s Manual.
- Page 8 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Mounting hardware (not included) Mount the battery charger (optional). – No parts required Unfold the handle. Chute deflector Install the chute deflector. Chute-control rod Install the chute-control rod.
-
Page 9: Unfolding The Handle
Move the lower handle into place and install the lower handle knobs as shown in Figure Note: You may use a wrench on the hex on the outside of the knob to tighten the knob. Unfolding the Handle Important: Tighten the knobs until the handlebar touches the side plate with no gap. - Page 10 Installing the Chute Deflector Parts needed for this procedure: Chute deflector Procedure g316999 Figure 7...
-
Page 11: Installing The Chute-Control Rod
Installing the Chute-Control Parts needed for this procedure: Chute-control rod Procedure Ensure that the chute is facing forward (Figure With the handle facing forward, install the chute-control rod into the guide and push it down until it snaps into place (Figure g282249 Figure 8... -
Page 12: Product Overview
Contact your Authorized Service Dealer or authorized Toro distributor or go to www.Toro.com for a list of all approved attachments and accessories. To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. -
Page 13: Operation
Starting the Machine Operation Ensure that the battery pack is installed in the machine; refer to Installing the Battery Pack Installing the Battery Pack (page 13). Make sure that the vents on the battery are clear Insert the electric-start button into the electric of any dust and debris. -
Page 14: Activating Eco Mode
Activating ECO Mode Removing the Battery Pack from the Machine Using ECO mode may extend battery life by reducing rotor speed; use ECO mode whenever you are Lift up the battery-compartment lid. moving snow a short distance. Activate ECO mode using the ECO switch as shown in Figure Press the battery pack-latch to release the... -
Page 15: Adjusting The Discharge Chute And Chute Deflector
Adjusting the Discharge Clearing a Clogged Chute and Chute Deflector Discharge Chute To adjust the discharge chute, move the handle on WARNING the chute-control rod in the direction that you wish to direct the snow stream. Contacting a rotating rotor with your hands inside the discharge chute could cause To adjust the chute deflector (and therefore the height of the snow stream), squeeze the trigger and raise or... -
Page 16: Preventing Freeze-Up After Use
Preventing Freeze-up after • In snowy and cold conditions, some controls and moving parts may freeze. Do not use excessive force when trying to operate frozen controls. • After using the machine, engage the auger to clear any remaining snow from inside the housing. Shut off the machine, wait for all moving parts to stop, remove the key and battery, and remove all ice and snow from the machine. -
Page 17: Maintenance
Do not attempt to destroy or disassemble the battery pack or remove any of its components. Contact your local municipality or your authorized Toro distributor for more information on how to responsibly recycle the battery. -
Page 18: Troubleshooting
5. The auger/impeller drive belt is loose 5. Install and/or adjust the auger/impeller or is off the pulley. drive belt; refer to www.Toro.com for servicing information or take the machine to an Authorized Service Dealer. 6. The auger/impeller drive belt is worn 6. - Page 19 Notes:...
- Page 20 The Toro Company (“Toro”) respects your privacy. When you purchase our products, we may collect certain personal information about you, either directly from you or through your local Toro company or dealer. Toro uses this information to fulfil contractual obligations - such as to register your warranty, process your warranty claim or to contact you in the event of a product recall - and for legitimate business purposes - such as to gauge customer satisfaction, improve our products or provide you with product information which may be of interest.