Table of Contents
Advertisement
Steam
en
Setting the timer
The timer runs alongside other settings. You can set it
at any time, even if the appliance is switched off. It has
its own audible signal so that you can tell whether it is
the timer or a cooking time which has elapsed.
Adjusting settings
The timer duration always starts at zero minutes.
The higher the value, the greater the time steps when
setting the timer.
The maximum setting is 24 hours.
Touch the t field.
1.
The symbol lights up red. On the display, the timer
duration is shown in white and in focus.
Set the timer duration using the rotary selector.
2.
Press the t field to start.
3.
After a few seconds, the timer also starts
Note:
automatically.
The timer duration counts down.
The timer remains visible on the display if the appliance
is switched off. When an operation is running, the
settings for this operation are shown in the foreground.
When you touch the t field, the timer duration is
displayed for a few seconds.
When the timer duration comes to an end, an audible
signal sounds and a note appears on the display. The
symbol is no longer lit up.
If the set timer duration relates to the appliance
Tip:
operation, use the cooking time. The time is visible in
the foreground and the appliance switches off
automatically.
Changing and cancelling
To change the timer duration, touch the t field. The
timer duration is displayed in white and in focus, and
can be changed by using the rotary selector.
If you want to cancel the timer, reset the timer duration
to zero. Once the change has been applied, the symbol
is no longer lit up.
18
`Steam
W ith some heating modes, you can prepare food with
S t e a m
steam assistance. In addition, the Dough proving and
Reheat heating modes are available.
:
Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
Noise
Pump
You will hear a humming noise while the pump is in
operation and after switching it off. This noise is caused
by the pump function test. It is a normal operating
noise.
Control panel
You will hear a humming or clicking noise when
opening the control panel. These noises are caused by
the control panel being pushed out. They are normal
operating noises.
Steam baking – Steam-assisted cooking
When you cook with steam assistance, steam is
introduced into the cooking compartment at various
intervals and with varying degrees of intensity. This
gives you a better cooking result.
Your food
Becomes crispy on the outside
■
Develops a shiny surface
■
Is succulent and tender on the inside
■
Only undergoes a minimum reduction in volume
■
You set the type of heating and steam intensity
combination that you want. Use the information in the
tables to select a suitable type of heating and steam
intensity, or select a programme.
Steam intensity
Different intensity levels are available when adding
steam:
Intensity
Low
Medium
High
Suitable types of heating
You can switch on steam assistance for these types of
heating:
4D hot air <
■
Top/bottom heating %
■
Hot air grilling 7
■
Keeping warm O
■
Setting
01
02
03
Advertisement
Table of Contents
