Sealey MS062.V2 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction Wear eye
manual protection
1. SAFETY
WARNING! Ensure Health & Safety, local authority and general workshop practice requirements are adhered to when using this
‰
equipment.
WARNING! Always refer to the motorcycle manufacturer's service instructions, or a proprietary manual to establish the current procedure
‰
for removing motorcycle wheels.
Ensure that the motorcycle wheel and hub are in good condition.
9
Use the wheel bearing removal kit in a suitable work area. Keep the area clean and tidy and ensure there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
Keep hands clear of the drift and hammer when using the wheel bearing removal kit.
9
Wear appropriate personal protective equipment when using the wheel bearing removal kit. A full range of PPE is available from your
9
Sealey stockist.
DO NOT use the wheel bearing removal kit for any purpose other than for which it is designed.
8
DO NOT use the wheel bearing removal kit if any part of it is damaged or missing.
8
DO NOT allow untrained persons to use the wheel bearing removal kit.
8
DO NOT attempt to remove a motorcycle wheel bearing when you are tired or under the influence of alcohol, drugs or intoxicating
8
medication.
When not in use, clean the wheel bearing removal kit and store in a safe, dry, childproof area.
9
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must
be applied by the operator.
2. INTRODUCTION
UCT
For easy removal of wheel bearings. Simply choose the correct size collet for the bearing and hammer one of the drifts into the allocated slot.
Covers sizes from 10-25mm so will suit most popular motorcycles and ATV/Quad Bikes.
3. CONTENTS
U
ITEM
NO.
1
2
3
4
5
© Jack Sealey Limited
9pc MOTORCYCLE WHEEL BEARING REMOVAL
KIT
MS062
MODEL NO:
Wear protective
gloves
DESCRIPTION
Large Drift - 400 mm
Small Drift - 250 mm
Ø10 mm Collet
Ø12 mm Collet
Ø15 mm Collet
Original Language Version
.
V2
ITEM DESCRIPTION
NO.
6 Ø17 mm Collet
7 Ø19 mm Collet
8 Ø20 mm Collet
9 Ø25 mm Collet
MS062.V2 Issue: 1 - 21/10/20