Page 1
PER-T481 Intel® GbE LAN PCI-E [x4] Frame Grabber Card PoE PCI-E [x4] Frame Grabber Card User’s Manual 6 Last Updated: February 15, 2023...
Page 2
Copyright Notice This document is copyrighted, 2023. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated, or transmitted in any form or by any means without the prior written permission of the original manufacturer.
Page 3
Acknowledgement All other products’ name or trademarks are properties of their respective owners. Microsoft Windows® is a registered trademark of Microsoft Corp. ⚫ Intel®, Pentium®, Celeron®, Atom®, and Xeon® are registered trademarks ⚫ of Intel Corporation Core™ is a trademark of Intel Corporation ⚫...
Page 4
Packing List Before setting up your product, please make sure the following items have been shipped: Item Quantity PER-T481 ⚫ Utility CD ⚫ If any of these items are missing or damaged, please contact your distributor or sales representative immediately. Preface...
Page 5
About this Document This User’s Manual contains all the essential information, such as detailed descriptions and explanations on the product’s hardware and software features (if any), its specifications, dimensions, jumper/connector settings/definitions, and driver installation instructions (if any), to facilitate users in setting up their product. Users may refer to the AAEON.com for the latest version of this document.
Page 6
Safety Precautions Please read the following safety instructions carefully. It is advised that you keep this manual for future references All cautions and warnings on the device should be noted. Make sure the power source matches the power rating of the device. Position the power cord so that people cannot step on it.
Page 7
If any of the following situations arises, please the contact our service personnel: Damaged power cord or plug Liquid intrusion to the device iii. Exposure to moisture Device is not working as expected or in a manner as described in this manual The device is dropped or damaged Any obvious signs of damage displayed on the device...
Page 8
FCC Statement This device complies with Part 15 FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cause undesired operation. Caution: There is a danger of explosion if the battery is incorrectly replaced.
Page 10
China RoHS Requirement (EN) Hazardous and Toxic Materials List AAEON System QO4-381 Rev.A0 Hazardous or Toxic Materials or Elements Component Name PCB and Components Wires & Connectors for Ext.Connections Chassis CPU & RAM HDD Drive LCD Module Optical Drive Touch Control Module Battery This form is prepared in compliance with the provisions of SJ/T 11364.
PER-T481 Specifications System Bus Interface PCI-Express® [x4], Gen 2 PCI-Express Specification Revision 2.0 at 5GT/s — USB Connector — Ethernet LAN: Intel® i211AT Ethernet Controller x 4 (A10) Intel® i211AT Ethernet Controller x 2 (A20) Fully compliant with IEEE 802.3 and IEEE 802.3u Supports IEEE 1588 precision time synchronization PoE: Intel®...
Page 15
Power Supply Power Requirement LAN: Max. 10W PoE: 4 PoE Dual SATA Power (15-pin) DC Input 12~24V, Max. 90W for 4 Ports (A30) 2 PoE Dual SATA Power (15-pin) DC Input 12~24V, Max. 60W for 2 Ports (A40) Mechanical LAN: 4.3” x 5.3” (110mm x 136mm) Dimensions (W x D) PoE: 4.4”...
2.1.3 List of Connectors Please refer to the table below for all of the system’s connectors that you can configure for your application Label Function Connector Type RJ45.12P .90D(F).Notch LAN Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D RJ45.12P .90D(F).Notch LAN Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D RJ45.12P .90D(F).Notch LAN Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D RJ45.12P .90D(F).Notch...
2.2.3 List of Connectors Please refer to the table below for all of the system’s connectors that you can configure for your application Label Function Connector Type RJ45.12P .90D(F).Notch LAN Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D RJ45.12P .90D(F).Notch LAN Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D Chapter 2 – Hardware Information...
2.3.3 List of Connectors Please refer to the table below for all of the system’s connectors that you can configure for your application Label Function Connector Type SATA SATA Connector CONNECTOR.15P .90D(M).DIP .1.27mm.TECHBEST.J09-0404-01 RJ45.12P .90D(F).Notch Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D RJ45.12P .90D(F).Notch Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D RJ45.12P .90D(F).Notch...
2.4.3 List of Connectors Please refer to the table below for all of the system’s connectors that you can configure for your application Label Function Connector Type SATA SATA Connector CONNECTOR.15P .90D(M).DIP .1.27mm.TECHBEST.J09-0404-01 RJ45.12P .90D(F).Notch Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D RJ45.12P .90D(F).Notch Connector down.W/LED(L-G:R-O/G).DIP .UDE.RC1-1Q00000D SATA...
Driver Installation The PER-T481 comes with a product CD that contains all the drivers and utilities you need to set up your product. Insert the CD and follow the steps in the autorun program to install the drivers. In case the program does not start, follow the sequence below to install the drivers. Install LAN Driver Open the folder and select your OS Open the .exe file in the folder...