In the case of 30" and 36" wide appliances 2 adjacent
furniture doors can be attached instead of one large
door. These furniture doors must be connected to
a metal strip on the rear.
This metal strip can be purchased from customer
service as an optional accessory, see the section on
Optional accessories" on page 17.
When attaching the metal strip to the furniture doors,
observe the maximum possible length of the screws and
the position of the drill holes. Always screw into the best
load bearing material of the furniture door.
Never screw into fillers, decorative strips or similar.
If only one furniture door is to be attached to the
i
door of a 30" or 36" wide appliance, attach the
supplied sandwich plate to the adjusting rail and
lock into position.
19. Loading the appliance door
When attaching the furniture doors, it is recommended
to load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
18" Appliance 22 lbs / 10 kg
24" Appliance 33 lbs / 15 kg
30" Appliance 44 lbs / 20 kg
32
20. Attaching the adjusting rail
The adjusting rail is the most important means of
i
adjusting the furniture front.
Unscrew the installation support part from the
q
appliance door.
Using the positioning aid, set both longitudinal sides
i
of the furniture door parallel.
Measure the distance X between the adjusting rail
q
and the overhead furniture/fixtures.
Get other manuals https://www.bkmanuals.com
to the furniture door