Replacing Fuse; Power Trim And Tilt Will Not Operate - Yamaha F40G Owner's Manual

nents for damage. Also, check the boat
for damage.
3. Whether damage is found or not, return
to the nearest harbor slowly and careful-
ly.
4. Have a Yamaha dealer check the out-
board motor before operating it again.
EMU30682

Replacing fuse

If a fuse has blown, open the fuse holder and
remove the fuse with a fuse puller. Replace
it with a spare one of the proper amperage.
EWM00631
WARNING
Substituting an incorrect fuse or a piece
of wire could allow excessive current
flow. This could cause electric system
damage and a fire hazard.
Consult your Yamaha dealer if the new fuse
immediately blows again.
1
3
2
1. Fuse (20 A  3, 30 A)
2
1
ZMU05099
Trouble Recovery
2. Spare fuse (20 A  3, 30 A)
3. Fuse puller
2
1
1. Fuse (15 A, 20 A, 30 A)
2. Spare fuse (15 A, 20 A, 30 A)
3. Fuse puller
1
1. Fuse puller
EMU29525

Power trim and tilt will not operate

If the engine cannot be tilted up or down with
the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit, the engine can be tilted
manually.
1. Loosen the manual valve screw by turn-
3
ZMU07093
ZMU04337
97