Sealey AK3992 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this
‰
equipment.
Familiarise yourself with the application and the limitations of the riveter, as well as the potential hazards.
9
Maintain the riveter in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the riveter clean for best and safest performance.
9
Check moving parts alignment on a regular basis.
9
DO NOT hold the workpiece by hand. Secure unstable workpiece with a clamp, vice or other adequate holding device.
8
Ensure the workpiece is correctly secured before using the riveter.
9
DO NOT use the riveter for any purpose other than that it was designed for.
8
DO NOT operate the riveter if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
When not in use store in a safe, dry, childproof location.
9
2. INTRODUCTION
360° Swivel head gives greatly improved accessibility. Four nozzles for standard rivets and four mandrels for rivet nuts. Pressed steel body
with cast swivel head and Chrome Molybdenum steel jaws. Rubber grip handle for added comfort. Supplied with nozzle spanner.
3. SPECIFICATION
Model no.: ................................................................ AK3992
Includes: Four nozzles for standard rivets (2.4mm(3/32"),
3.2mm(1/8"), 4mm(5/32") and 4.8mm(3/16") and four mandrels
For rivet nuts. (M3, M4, M5, M6)
Length: ....................................................................... 275mm
Rivet Types: Aluminium -Yes, Steel -Yes, Stainless Steel - Yes
© Jack Sealey Limited
SWIVEL HEAD 2-IN-1 RIVETER
AK3992
MODEL NO:
Original Language Version AK3992 Issue 1 15/03/22