Toro 08719 Operator's Manual

Finish Brush Kit
Flex
Model No. 08719
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
number of your product ready.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 1), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Weight (Sand Pro 2040Z Only)
Brush assembly (left-hand)
Brush assembly (right-hand)
Screw (1/4 x 1-1/4 inch)
Locknut (1/4 inch)
Brush assembly (center)
Screw (1/4 x 7/8 inch)
Locknut (1/4 inch)
© 2023—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
™ Tooth Rake for Sand Pro
www.Toro.com for
Qty.
2
1
1
4
4
1
2
2
Register at www.Toro.com.
® Traction Units
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
WARNING
CALIFORNIA
Proposition 65 Warning
Use of this product may cause exposure
to chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Install the weights (Sand Pro 2040Z Only).
Install the side brushes.
Install the center brush.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3465-223 Rev A
Operator's Manual
Figure 1
Use
*3465-223*
g000502