Advertisement
Supplied accessories
Confirm that the following accessories have been provided with the product.
□
□
Mounting bracket x 2
Countersunk bolt (M10) x 2
□
□
M8 bolt x 4
M8 spring washer x 4
□
□
M10 bolt x 4
M8 plain washer x 4
□
□
M16 bolt x 8
M16 spring washer x 4
Precautions on use
•
The installation, removal, or transportation of the LCD Monitor must be performed by qualified service personnel.
The LCD Monitor is large and heavy. Installation requires special knowledge and qualifications.
•
Customers should not attempt to install, remove, or transport the LCD Monitor by themselves.
•
SHARP shall have no liability for any accidents or damages caused by improper installation or mishandling.
•
The installation requires two H-shaped steel frames set upright with bored mounting screw holes. For details, contact your
product dealer.
Installation procedure
Caution
•
The LCD Monitor is large and heavy. It must be moved with a hoisting device (chain block, etc.).
•
Installation requires at least four people.
1
Move the LCD Monitor in front of the H-shaped steel
frame to which it will be attached.
2
Insert the hooks of the hoisting device into the eye
bolts of the LCD Monitor and slightly lift the monitor.
•
Lift up the monitor so that the hoisting chains become
taut.
□
M16 plain washer x 4
□
M10 (countersunk bolt) plain washer x 2
□
Operation manual (this manual)
3
Remove the stand mounting bolts on the rear and
detach the LCD Monitor from the stand.
•
Loosen the 8 bolts gradually and evenly.
If it is difficult to loosen the bolts, lift the monitor up
slightly with the hoisting device to reduce the load on
the bolts.
•
Check the hoisting condition frequently to prevent the
LCD Monitor from falling.
- 2 -
4
Attach the mounting brackets on the rear of the LCD
Monitor.
1)
Attach 4 supplied M16 bolts, 2 on the right and 2
on the left as shown below, and slightly tighten the
bolts.
2)
Attach the mounting brackets by inserting the bolts
through the 2 holes in the center.
3)
Secure the mounting brackets with 4 supplied M16
bolts inserted into the remaining 2 holes on each
side.
4)
Fully tighten the bolts which were tightened halfway
in step 1).
5
Attach the supplied M10 bolts to the H-shaped steel
frame so that you can hook the LCD Monitor
(mounting brackets).
1)
Attach the bolts onto the both sides of the right and
left frames and ensure that all 4 of the bolts are
aligned at the same height.
Get other manuals https://www.bkmanuals.com
6
Attach the LCD Monitor (mounting brackets) to the
H-shaped steel frame.
1)
Hook the bottoms of the mounting brackets to the
bolts attached in step 5.
2)
Confirm that the mounting brackets are securely
hooked and then attach the 2 supplied countersunk
bolts.
3)
Tighten the countersunk bolts while gradually
loosening the chains of the hoisting device.
Countersunk bolt
Countersunk bolt
plain washer
M16 plain washer
M16 spring washer
4)
Insert the 4 supplied M8 bolts from the sides of the
mounting brackets (2 for each) and secure them.
7
Confirm that the LCD Monitor is mounted securely,
and then remove the hooks of the hoisting device.
- 3 -
M8 plain washer
M8 spring washer
Advertisement
