Make Connections - Bosch DIVAR hybrid 3000 Installation Manual

DIVAR 2000 | DIVAR 3000 | DIVAR 5000
4.2

Make connections

Notice!
Use only PoE approved devices.
1.
2.
3.
Optional connections (depending on model)
–
–
–
–
–
–
–
–
–
–
–
–
Bosch Security Systems B.V.
Qty Component
1 Split cable for loop through to 25-pin D-connector (only for DIVAR 5000 hybrid
models)
1 RJ11 adapter cable to connect Bosch Intuikey keyboard (only on DIVAR 5000
models)
Installation guides for Recorder, HDD, plus safety instructions
Connect the cameras to the
– If using PoE connector, power is supplied to the camera via the Ethernet cable
compliant with the Power-over-Ethernet standard.
– Use an external switch to connect more cameras to a single RJ45
Connect monitor A to the
Connect the USB mouse to a USB port (back or front panel).
On DIVAR models, connect a second dual monitor to the HDMI MON.B (hybrid models) or
HDMI MON.A2 (network 5000 models) connector.
Connect up to 4 audio signals to the
record audio only for analog input1, 2, 3 and 4).
Connect 1 microphone to the
only available via the network on the PC where the recorder Web Client is running).
Connect 1 RCA (CINCH) output from
(audio out can be: live audio from IP cameras, recorded audio or audio from the PC
where the recorder Web Client is running).
Connect up to 16 alarm inputs to the
blocks) - see description in Hardware setup.
Connect up to 6 alarm outputs to the
blocks) - see description in Hardware setup.
Connect a pan/tilt/zoom control unit to the
description in Hardware setup.
Connect to your network via the RJ45 ETHERNET connector
Pair Category 5e cable).
Connect extra video out cables to the
devices (only for DIVAR 5000 hybrid).
Connect a Bosch Intuikey keyboard cable to the
adaptor (only for DIVAR 5000) - see description in Hardware setup.
Connect an eSATA storage device to the
Connect the DIVAR to an approved ground point. Use the ground screw (supplied in the
accessory bag) to attach a ground cable to the DIVARback panel ground point
or connectors.
output, or the
RCA (CINCH) inputs (hybrid models only,
RCA (CINCH) input (audio from the microphone is
connector (via the supplied terminal
connector (only for DIVAR 5000).
Installation manual
Installation | en
output.
to the monitor or an audio amplifier
connector (via the supplied terminal
(only for hybrid models) - see
(use Shielded Twisted
ports if loop through is required to other
connector using the supplied
2020-05 | V4.0 | AM18-Q0712
11
port.
.