IE-78K0-NS-P04, IE-1615-NS-EM4
<2> Prepare the IE-78K0-NS-P04 Emulation Board.
<3> Remove the crystal oscillator that is mounted in the IE-78K0-NS-P04 Emulation Board's socket
(the socket marked as "X1").
<4> Connect the parts board (from <1> above) to the socket (X1) from which the crystal oscillator was
removed (see <3> above). Check the pin 1 mark to make sure the board is mounted in the correct
direction.
<5> Install the IE-78K0-NS-P04 Emulation Board and the IE-1615-NS-EM4 Probe Board in the IE-78K0-
NS-A.
The above steps configure a circuit and enable clock output to be supplied from the mounted oscilla-
tor to the emulation device.
CA
Remark:
The section enclosed in broken lines indicates parts that are attached to the parts board.
42
Figure 3-19: IE-78K0-NS-A side
10 MΩ
HCU04
HCU04
9 8
5
Rx
10
4
11
3
13
CB
12
2
JP8
1
2
3
4
Target
5
6
system
CLK IN