Craftsman 152.213351 Owner's Manual page 12

2. Hnsert two5/16-18 x 5/8"buttonheadcarriage boHts
through theinsideofthe intake funnei a ndintake
support b race.
iNTAKE PORT CAP AND
HOSE ASSEMBLY
3. Piace a 5/16-18 flange hex nut onto the button
head carriage boits and tighten secureiy.
F
E
D
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Fig. 14
A
C
4,
Attach the upper support bracket (C) to the hob (D)
in the intake support brace with the adjustabie Hock-
ing iever (E). Piace a 5/16" Hockwasher (F) onto
Hocking iever boit before attaching to the intake
support brace. See figure 12.
1,
E D
SHde the collar (A) of the intake port cap (B) over
intake port (C). Make sure the collar is position to
the back if you intend to attach the hose at this
time. See figure 14.
Fig 13 .J_--..........
G
2. PHace 4-inch hose champ (D) onto the end of 4qnch
fiexibie hose (E). See figure 14.
3. Siide end of 4-inch fiexibie hose with 4-inch hose
champ onto intake port and tighten secureiy.
IMPORTANT: When connecting a flexibie hose to
intake port, DO NOT REMOVE THE INTAKE PORT
CAP COLLAR FROM THE INTAKE PORT. Siide the
collar further back when attaching a fiexibie hose.
5,
Place intake funnel assembly (G) onto lower sup-
port tube (H) and tighten tube clamp (I) securely,
See figure 13,
12