Oven - GE Profile PLD617 Owner's Manual And Installation Instructions

boiling. The rear burners are intended for general
cooking and simmering.
without cookware on the grate. The finish on the grate
may discolor or chip without cookware to absorb the
heat.
another burner is on. Damage to the product may
occur.
The proper install orientation for the grate is as shown.

Oven

Lighting the Oven
NOTE:
valve is opened.
2. Push and turn the oven control knob counterclockwise
to the position.
3. Keep the oven control knob pressed and rotate the
ignition knob clockwise continuously until the oven
pilot is lit. The oven pilot is located at the rear right of
the bake burner in the burner compartment.
4. Once the oven pilot is lit, keep the oven control knob
sensor becomes heated.
place you hand, a pot holder or cleaning materials on
the cooktop.
Size cookware appropriately to the flames. The rear
burners are intended for general cooking and simmering.
a boil faster.
5. Release oven control knob and visually confirm
oven pilot remains lit. If oven pilot goes out, repeat
steps 3 and 4.
6. Rotate the oven control knob to the highest oven
temperature and visually confirm that the pilot has
ignited the bake burner.
Close oven door
WARNING
In the event of an ignition system
failure, the oven is inoperable and no attempt should
be made to operate it. Do not attempt to light the
oven manually.
WARNING
Do not store objects in burner
compartment.
Oven Pilot
Compartment
49-2001047 Rev. 5