Switching On/Off The Unit; Faceplate Release; Sound Adjustment - AEG CS FMP 500 USB Owner's Manual

OPERATION

SWITCHING ON/OFF THE UNIT

Switch on the unit by pressing any button
(except OPEN button (7) and
When system is on, press power button (9)
to turn off the unit.

FACEPLATE RELEASE

Press RELEASE button (7) to detach the
removable faceplate.

SOUND ADJUSTMENT

Press PUSH SEL button (10) to
select the desired adjustment mode. The
adjustment mode will change in the
following order:
Volume Bass Treble Balance Fader
By rotating the knob (10) clockwise or
counter-clockwise, it is possible to adjust
the desired sound quality.
Press PUSH SEL button (10) for several
seconds, it is activated as cyclical mode
of following functions for user's selection.
PI SOUND or MUTE
TA SEEK or ALARM
MASK DPI or ALL RETUNE L or S
BEEP 2'nd or OFF
a) TA SEEK OR TA ALARM
- TA SEEK mode:
When newly tuned station does not
receive TP information for several
seconds, the radio retunes to next
station which has not the same
station (PI) as the last station, but
has the TP information.
When TP information gets lost at the
current station for retune time which
is set by RETUNE SHORT (30 sec.)
or RETUNE LONG (90 sec.), the
radio start to retune to next same PI
station. When same PI station does
not catch in 1 cyclic search, the
radio retunes to next station with TP
information.
- TA ALARM mode:
When this mode is selected, any
button (4)
automatic retune mode is not
activated. Only double beep sound
(ALARM) is output.
When newly tuned station does not
have TP information for several
seconds, beeps come out.
When TP information gets lost at the
shortly
current station for retune time, the
beep sound is out-putted.
When newly tuned station has no
RDS signal, "PI SEEK" is
suppressed somewhat.
b) PI SOUND or PI MUTE
While AF switching is implemented in
C201 station, AF can switch to 100
MHz, which is non genuine AF (where,
different PI with same AF) in short
"DIP".
If a car cruises that critical area back
and forth, an oscillation
phenomenon can be occurred,
because the different PI code can be
received from 100 MHz with "XXX"PI.
The car radio has special procedure
to reduce even this kind of
unavoidable situation however there
is a limit to be escaped from this
serious case perfectly.
In that serious case, 2 mode is
selectable as follows:
98
90
100
PI: C201
- PI SOUND mode:
When above different PI sound (DIP)
is heard once in a while, the DIP's
sound will be heard for a short time.
9
100
PI: XXX