Open Source Software License - Epson UB-E04 User Manual

Hide thumbs Also See for UB-E04:

Reference manual (43 pages)

User manual (8 pages)

User manual (2 pages)

Table of Contents

Note:

Although the example shows the address 192.168.192.168, use whatever IP address

is reported on the status sheet.

Because the default IP addresses for all the printers are the same, you should power

on and configure only one printer at a time.

Resetting the product to Factory Defaults

Hold down the push button on the interface card while turning on printer power and

continue to hold it down until a message that initialization starts is printed. This causes

all internal settings to return to their factory defaults.

Setup

There are two ways for the setup. For details, see the UB-E04 Technical Reference Guide.

❏

Using a Web browser

Input the IP address of this product in the address bar of the browser and

press Enter.

(Example: http://192.168.192.168 [default]).

In the User authentication screen, enter "epson" for [user] and the printer

serial number (10 digits, case-sensitive) for [password]. (default)

*[user] is fixed to "epson" but you may change [password].

Set parameters in each menu. If a parameter is changed, press [Send] to send

settings to the printer.

In the screen displayed after sending settings, press [Reset] to enable settings.

When changing the IP address, etc., make sure settings in the host PC match

that of the printer.

❏

Using the EpsonNet Config (Ver. 4.5.7 or later)

The EpsonNet Config is a utility to make network settings on an Epson printer

with an Ethernet interface or a wireless LAN interface.

You can download the Technical Reference Guide and the EpsonNet Config from one

of the following URLs.

For customers in North America: www.epson.com/support/

For customers in other countries and regions: www.epson-biz.com/