Removing The Versa Vac From The Tractor; Greasing The Machine - Toro Versa Vac 07053 Operator's Manual

1
Figure 4
1. Safety chain
Caution
If shield chains are not connected, they could
rotate during operation and cause bodily injury.
Keep all PTO shields in place and connect the
shield chain to the tractor or PTO shields.
Removing the Versa Vac from
the Tractor
1. Stop the tractor on a level surface, not on a slope.
2. Disengage the PTO and engage the parking brake.
3. Stop the engine and remove the key from the ignition
switch.
Caution
Before leaving the operator's seat on the tractor,
wait for the engine and all moving parts to stop.
4. Block the wheels.
5. Disconnect the safety shield chains from the tractor or
PTO shield. Secure the end of the chain to the impeller
side of the PTO shaft to prevent the PTO shaft from
coming apart.
6. Disconnect the PTO shaft from the tractor output shaft.
7. Slide the PTO shaft back and remove it from the tractor.
8. Remove pin securing jack to frame pin and rotate jack
down into position.
9. Secure jack to frame pin and adjust jack to support vac.
10. Remove hitch pin and clevis.
11. Drive tractor away.
Warning
Trailer is very heavy. Do not disconnect the trailer
without first putting down the jack.
• Personal injury could occur if hitch drops.

Greasing the Machine

Before the machine is operated, the PTO shaft must be
greased to ensure proper lubricating characteristics; refer to
Greasing the Machine in the Maintenance section; page 16.
Failure to properly grease the unit will result in premature
failure of critical parts.
11