Table of Contents
Advertisement
10
www.aeg.com
5.2 Positioning and levelling
1. Install the appliance on a flat hard
floor.
Make sure that carpets do
not stop the air circulation
below the appliance.
Make sure that the appliance
does not touch the wall or
other units.
2. Loosen or tighten the feet to adjust
the level.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
The appliance must be level and stable.
A correct adjustment of the
appliance level prevents the
vibration, noise and the
movement of the appliance
when in operation.
When a tumble dryer is
stacked on the washing
machine, use the accessory
described in chapter
'Accessories'. Read carefully
the instructions supplied with
the appliance and with the
accessory.
5.3 The inlet hose
1. Connect the water inlet hose to the
back of the appliance.
2. Position it toward left or right
depending on the position of the
water tap.
20º
20º
x4
3. If necessary, loose the ring nut to set
it in the correct position.
4. Connect the water inlet hose to the
cold water tap with 3/4" thread.
45º
45º
Make sure that the inlet hose
is not in vertical position.
WARNING!
The inlet water shall not
exceed 25 °C.
Advertisement
Table of Contents
