Sealey WST10000 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction gloves
manual
1. SAFETY
1.1. ELECTRICAL SAFETY
WARNING! Must be installed by a qualified electrician.
‰
WARNING! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage.
Electrical safety information, it is important that the following information is read and understood.
1.1.1. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or replaced is repaired/replaced
8
immediately by a qualified electrician.
1.1.2. All circuits supplying the inputs of transformers must be protected. It should be noted that the input current on switch on may exceed
20 times the normal load current. This may cause some types of protective current to open. This should be borne in mind when
selecting protective devices.
Sealey recommend that installation work and repairs are carried out by a qualified electrician.
1.2. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
transformer.
Familiarise yourself with the application and limitations of the transformer, as well as the potential hazards.
9
WARNING! Disconnect the transformer from the mains power before performing any maintenance.
‰
Maintain the transformer in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.
9
WARNING! DO NOT connect to mains if any parts are damaged or missing as this may cause failure and/or personal injury.
‰
Keep the transformer clean for best and safest performance.
9
Keep children and unauthorised persons away from the working area.
9
DO NOT use the transformer for any purpose other than that for which it is designed.
8
DO NOT exceed the rated capacity of the transformer.
8
DO NOT allow untrained persons to use the transformer.
8
DO NOT use the transformer when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
When not in use unplug from the mains power supply and store in a safe, dry, childproof area.
9
2. INTRODUCTION
i
110V Transformer with tool rated performance suitable for intermittent running of power tools and continuous running of lighting products within
specified capacity. IP44 Rated unit with steel case and heavy-duty handles to aid positioning. Fitted with Miniature circuit breaker to prevent
overload. Supplied with 2 x 32A/110V sockets and 4 x 16A/110V sockets.
© Jack Sealey Limited
110V 10KVA SINGLE PHASE SITE TRANSFORMER
WST10000
MODEL NO:
Isolating Warning:
Transformer Electricity
Original Language Version
Warning:
Hot surface
WST10000 Issue 3 (2,3) 15/07/22