Summary of Contents for Panasonic OneHome BB-HCM581A
Page 1
OneHome™ Camera Integration Note Management and Control Solutions Manufacturer: Panasonic Model Number(s): BB-HCM580A/581A Comments: OneHome version 4.0.1310 or newer, Network Camera (version 3.10) Document Revision Date: 5/19/2011 NOTE: This document refers to Camera setup in software versions below 5.2 ONLY.
AMERA ONFIGURATION The camera configuration is done with software provided by Panasonic, which must be run from a computer with Windows also connected to the same network as the camera. The software program from Panasonic is EasyConfig.exe: the version we checked is shown at the top.
Page 3
3. Wait a moment to allow the software to find the camera: the following screen appears. 4. Select the desired camera, and then click the Access Camera button. After a short delay you will see a new browser window with the initial password screen below: 5.
Page 4
7. You will be prompted to enter your user name and password to login, as shown in the image below. Type in the user name and password you just set, and click OK. AMERA ETTINGS 1. After typing in your user name and password, you will be shown the standard browser interface to the camera.
Page 5
4. Click UPnP on the left, then click Disable in the both parts of the screen, as shown below. Click Save to store your settings. 5. Under Accounts to the left, click Administrator to bring up the screen below. Click Permit access from guest users, as shown below.
Page 6
6. Click on General User under Accounts. Click on Guest User and the click the Modify button. 7. Set Video Display time to Unlimited, and then click the Level 3 button to automatically check all boxes on the page. Save when finished. 6 of 10...
Page 7
8. Click Network (IPv4) to bring up the network settings screen shown below. 7 of 10...
Page 8
9. Click Static in the Connection Mode to bring up the screen below. 10. Set the IP address to the desired value: we suggest setting the first camera to 192.168.0.80, the second to 192.168.0.81, and so forth. Set the Default Gateway and the 1 DNS server to the router IP Address, and then click Save to save the settings.
Page 9
OGIC ONFIGURATION To use Panasonic IP Cameras with the HomeLogic DVR tab, enter the web configuration by typing the camera IP into the browser and logging on using your username and password. Click Setup, and then below Buffer/Transfer click Motion Detection. Threshold is the measure of the camera’s sensitivity to change—a lower setting will cause it pick up smaller changes.
Page 10
N/A (See Note 1) Communication Device N/A (See Note 1) Video Cameras Name <User Defined> Device Type Panasonic KX-HCM280A Location <User Defined> (Not Required) <User Defined> (Default: 192.168.0.80) (See Note 2) IP Address Port Typically left at 80 <User Defined> (Default: Administrator) UserName <User Defined>...