1. Manuals
  2. Brands
  3. Craftsman Manuals
  4. Garage Door Opener
  5. 200.57933
  6. Owner's manual

Craftsman 200.57933 Owner's Manual

Hide thumbs Also See for 200.57933:
Table of Contents

Advertisement

Quick Links

Owner's Manual/Manual Del Propietario
GARAGE DOOR OPENER
Abridor de puerta de cochera
MODEL/MODELO 200.57933
Read and follow all safety rules and operating
instructions before first use of this product.
Fasten the manual near the garage door after
installation.
Periodic checks of the opener are required to
ensure safe operation.
DO NOT install on a one-piece door.
Write down the Craftsman
®
serial number located on the garage door opener:
Anote en el recuadro el número de seria de Craftsman ubicado en el abre-puerta:
Sears Brands Management Corporation, Hoffman Estates, IL 60179 U.S.A
www.craftsman.com
For Residential Use Only
Sólo para uso residencial
Leer y seguir todas las reglas de seguridad y
las instrucciones de operación antes de usar
este producto por primera vez.
Guardar este manual cerca de la puerta de la
cochera.
Se deben realizar revisiones periódicas del
abridor de puertas para asegurar su
operación segura.
Los dispositivos y funciones automáticas
deben usarse ÚNICAMENTE con puertas
seccionales.
Spanish Section Begins Page: 29
Manual en Español empieza en la pagina: 29
SEOMU01A-1

Advertisement

Table of Contents
loading

Related Manuals for Craftsman 200.57933

Summary of Contents for Craftsman 200.57933

  • Page 1 ® serial number located on the garage door opener: deben usarse ÚNICAMENTE con puertas Anote en el recuadro el número de seria de Craftsman ubicado en el abre-puerta: seccionales. Spanish Section Begins Page: 29 Manual en Español empieza en la pagina: 29 Sears Brands Management Corporation, Hoffman Estates, IL 60179 U.S.A...

  • Page 2: Table Of Contents

    Table of Contents Introduction Symbols and Icons Inventory Preparation / Tools Required Assembly Rail and Trolley Assembly Installing the Cable and Chain Important Installation Instructions Mounting Header Bracket Installation Attaching Rail to Header Bracket and Mounting Door Bracket Mounting Opener to Ceiling Attaching Door Arms Installing Light and Emergency Release Handle Wiring...

  • Page 3: Inventory

    Inventory Rail — Header Segment Rail — Middle Segments x3 Opener Unit + Light Lens Cover Rail — End Segment with Trolley Stop Bolt Photo Eye Safety System OPTIONAL OPTIONAL Screw #6 x 1” Drywall Anchor 3-Button Mini 1-Button Push Button Sprocket Cover Remote* Wireless Keyless Entry Keypad*...

  • Page 4: Preparation / Tools Required

    Preparation WARNING To prevent SERIOUS INJURY or DEATH: - Before beginning installation of the opener please complete the following test to ensure that your door is balanced and in good working condition. - A poorly balanced door can cause serious injury and damage to the opener. - Always have a qualified garage door service technician make any required adjustments and/or repairs to your door before proceeding with installation.

  • Page 5: Rail And Trolley Assembly

    If the supplied chain and rails are not long enough for your installation, you may purchase an 8-foot or 10-foot Chain Drive Extension Kit. To purchase a kit, visit a Craftsman outlet ,call 1-888-331-4569,or go online to www.craftsman.com To Assemble Rail and Opener Cable Eyelet Prepare the rails as shown in Fig.1.

  • Page 6: Installing The Cable And Chain

    Installing Cable and Chain WARNING To prevent SERIOUS INJURY: - DO NOT connect power until instructed. - Keep hands and fingers clear from sprocket during operation. - Wear gloves when installing chain and cable. - Keep hands and fingers away from joints and possible sharp edges. To Install Chain Cable Rail Bracket...

  • Page 7: Important Installation Instructions

    Important Installation Instructions IMPORTANT INSTALLATION INSTRUCTIONS WARNING To reduce the risk of severe injury or death: READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS. Install only on a properly balanced garage door. An improperly balanced door has the potential to inflict severe injury.

  • Page 8: Mounting Header Bracket

    Mounting Header Bracket WARNING To prevent SERIOUS INJURY: - DO NOT connect power until instructed. - The header bracket MUST be SECURELY fastened to the structural support on the mounting wall or ceiling, otherwise the door may not reverse when required. DO NOT install the header bracket over drywall. - Concrete anchors MUST be used when mounting the header bracket into masonry.

  • Page 9: Attaching Rail To Header Bracket And Mounting Door Bracket

    Attaching Rail to Header Bracket and Mounting Door Bracket CAUTION To prevent SERIOUS INJURY: - DO NOT connect power until instructed. - REINFORCEMENT is recommended for fiberglass, aluminum or lightweight steel garage doors BEFORE installing the door bracket. Contact your door manufacturer for reinforcement options. To Attach the Opener to the Header Bracket As shown in Fig.1, use the packaging carton as temporary support for the opener.

  • Page 10: Mounting Opener To Ceiling

    Mounting Opener to Ceiling WARNING To prevent SERIOUS INJURY or DEATH: - DO NOT connect power until instructed. - Install the opener at least 7 feet (2.13m) above the floor. - Fasten the opener SECURELY to STRUCTURAL SUPPORTS of the garage to prevent falling. - If installing brackets to masonry, concrete anchors (not provided) MUST be used.

  • Page 11: Attaching Door Arms

    Attaching Door Arms WARNING To prevent SERIOUS INJURY: - DO NOT connect power until instructed. - Keep hands and fingers away from the sprocket during operation. - Wear gloves when installing chain and cable. - Keep hands and fingers away from joints and possible sharp edges. Min.

  • Page 12: Installing Light And Emergency Release Handle

    Installing Light and Emergency Release Handle WARNING To prevent SERIOUS INJURY or DEATH from electrocution: - Disconnect power cord before installing/replacing light bulb. To prevent possible OVERHEATING or damage to opener: - Use ONLY A19 (E26) incandescent bulbs* (100W max.). - DO NOT use short neck or specialty light bulbs.

  • Page 13: Wiring Instructions

    Wiring Instructions WARNING To prevent SERIOUS INJURY or DEATH from electrocution: - Power MUST NOT be connected until instructed. - NO exposed part of the wire should be visible outside of the terminal for proper connection. * VERY IMPORTANT! * In the following section, the photo eye safety system and Wire from accessories push button will be connected to the opener.

  • Page 14: Connecting Photo Eye Safety System

    Connecting Photo Eye Safety System WARNING To prevent SERIOUS INJURY or DEATH from electrocution: - Power MUST NOT be connected BEFORE photo eye safety system is connected and aligned. - The opener will not operate until the photo eye safety system is properly connected and aligned. - Install the photo eyes NO higher than 6”...

  • Page 15: Connecting Push Button

    Connecting Push Button WARNING To prevent SERIOUS INJURY or DEATH from electrocution: - Power MUST NOT be connected until instructed. To prevent SERIOUS INJURY or DEATH from using the push button and a closing door: - Install the push button within sight of the door at a minimum height of 5 feet (1.5m) above the floor. Make sure it is out of the reach of children and moving parts of door and hardware.

  • Page 16: Connecting Power

    Connecting Power WARNING To prevent SERIOUS INJURY or DEATH from electrocution or fire: - Power MUST be DISCONNECTED BEFORE proceeding with permanent wiring procedures. - Garage door opener installation and wiring MUST be in compliance with all local electrical and building codes.

  • Page 17: Travel Limit Adjustment

    Travel Limit Adjustment WARNING To prevent SERIOUS INJURY or DEATH from improper force adjustment: - Improper adjustment of travel limits will cause operation of safety reversal mechanism. - If travel limit adjustment is made, force adjustment may also needed. - After ANY adjustments, the safety reverse test MUST be performed to ensure the door reverses on contact with a 1-1/2”...

  • Page 18: Force Adjustment

    Force Adjustment WARNING To prevent SERIOUS INJURY or DEATH from improper force adjustment: - DO NOT adjust force to compensate for binding or sticking of the garage door. Call a qualified garage door service technician to make necessary adjustments in case of binding. - DO NOT increase the force beyond minimum force required for closing the door.

  • Page 19: Final Adjustment And Testing

    Final Adjustments and Testing WARNING To prevent SERIOUS INJURY or DEATH from a closing garage door: - The Safety Reversal Test MUST be conducted ONCE A MONTH. - NO ONE should cross the path of moving door during operation and/or testing. - If either force or travel limit adjustment is made, the other adjustment may also needed.

  • Page 20: Programming 1 Button Remote

    Programming 1– Button Remote WARNING To prevent SERIOUS INJURY or DEATH: - Keep remote and battery out of reach of children. - NEVER permit children to access the wall panel nor remotes. - Operate the door ONLY when it is properly adjusted, and there are no obstructions present. - ALWAYS keep a moving door in sight until completely closed.

Table of Contents