Epson ActionNote 4SLC/33 User Manual page 142

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This device complies with FCC Rules, Part 15. Operation is subject to the following two
conditions
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
The correction of a telephone company line to this equipment, other than the one supplied
with the modem, will invalidate the FCC Certification of this device. It is the responsibility
of the user to connect and use only the ferrite-loaded telephone company line supplied
with this modem.
Changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate this equipment.
Note
FCC ID: JRUAM-3S25
comply with the limits for a Class B digital
to
WARNING
Fax/Modem Command Set B-15