Radio Operation; Cd Playback - Silvercrest KH 2302 Operating Instructions Manual

Radio operation

FUNCTION
• Press the button
indicator TUNER appears in the display.
Select frequency range
You can receive VHF (FM) and MW (AM) trans-
missions with the micro system.
• To select the frequency range, press the button
BAND
. In the display appears the indicator AM
or the indicator FM.
Stereo/Mono reception
If VHF reception is disturbed, switch over to
Mono reception with the button
During the switch-over, the indicators STEREO
resp. MONO appear briefly in the display.
With the setting STEREO, the stereo reception
of a VHF transmitter is shown in the display as
STEREO.
Automatic search function
• Briefly hold the button
down.
The search function begins and stops automatically
when a frequency with sufficient reception strength
has been found.
• To restart the search, once again briefly hold
SKIP
the button or
• To stop the search, press the button
SKIP
.
Manual search
With the manual search function you can carry out
a fine adjustment function of the stations, for example,
if reception is disturbed.
• To raise the reception frequency, briefly press the
SKIP
button .
• To lower the reception frequency, briefly press
SKIP
the button .
repeatedly until the
FIND ST./MONO
SKIP SKIP
or pressed
SKIP
. pressed down.
SKIP
or
Storing the stations (memory)
You can save stations in up to 45 programme
locations (30 x UKW and 15 x MW).
• Select the frequency range and tune in to the
desired radio station as previously described.
1.
To save the radio station, press the button
CLK-ADJ PROG/MEM
or
In the display blinks indicator 1 for the programme
location 1.
2.
Select the desired programme location with the
ALBUM PRESET +/-
button
3.
To confirm the programme location, press the
MEM CLK-ADJ
button
The station is now saved in the selected program
location.
.
Selecting saved stations
You can select the saved stations during radio
operation.
1.
With the button
in which the radio station has been saved.
2.
With the button
location.

CD Playback

• Press the button
indicator CD appears in the display.
Inserting a CD
1.
To open the CD compartment, press the button
OPEN/CLOSE
The flap of the CD compartment opens itself.
Note:
Ensure that the transport restraint has been
removed from the CD compartment before
the first use!
2.
Insert the CD into the CD compartment with
the printed side facing up.
3.
Press the CD down slightly, until it is firmly posi-
tioned on the axle.
- 28 -
.
.
PROG/MEM
or .
BAND
, select the frequency range
ALBUM PRESET +/-
select programme
FUNCTION
repeatedly until the
.
MEM