Table of Contents
Advertisement
Available languages
Available languages
LEVEL THE WASHER OR DRYER
4
Stand the washer or dryer upright. Move
A
it close to its final location.
Make sure that the washer or dryer
B
is level by placing a spirit level on top.
Check side to side and front to back.
Use an open
C
ended wrench
to adjust the
legs in and
out. Tighten
the lock nut
against the
bottom of
the pedestal.
NOTE: To minimize vibration, the locking
nuts must be tight.
REINSTALL THE DRAWER
5
Check to
A
be sure the
slides are
closed.
Slide the
B
drawer
Drawer
into the
divider
opening.
Align the
drawer
supports to
the slides on
each side.
Reinstall the original screws into each
C
drawer slide. Tighten both screws.
D
Open the drawer fully. Slide drawer
divider into slots in the center of the
drawer. The drawer should slide
smoothly when you push it closed.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Installation Instructions
3
REMOVE SHIPPING SCREWS
6
Remove the 4 shipping screws on the back side
of the washer.
7
FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation
Instructions to complete the installation.
Advertisement
Table of Contents
