Troubleshooting - Husqvarna ST 224P Operator's Manual

2. Remove the wheel from the axle (C).
A
B

Troubleshooting

Problem
The product does not start The safety ignition key is not inserted.
22
C
Troubleshooting
Possible cause
The product is out of fuel.
The ON/OFF key is OFF.
The choke is in OFF (CLOSE) position.
The primer is not depressed.
The engine is flooded.
The spark plug cable is not connected.
The spark plug is bad.
There is water in the fuel or the fuel is too old.
There is vapor locked in the fuel line.
Other causes.
The fuel switch (if equipped) is in CLOSE (OFF)
position.
The throttle is in STOP position.
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
Insert the safety ignition key.
Fill the fuel tank with fresh, clean
gasoline.
Move the ON/OFF key to ON posi-
tion.
Move the choke to ON (FULL,
OPEN) position.
Press the primer.
Wait a few minutes before restarting,
DO NOT prime.
Restart the engine while full throttle
and the choke in OFF (CLOSE) posi-
tion.
Connect the cable to the spark plug.
Replace the spark plug.
Empty the fuel tank and carburetor.
Fill the fuel tank with fresh, clean
gasoline.
Make sure that all the fuel line is be-
low the outlet of the fuel tank. The
fuel line should run continuously
down from fuel tank to carburetor.
Inspect the starting procedures care-
fully in this manual.
Turn the fuel switch to OPEN (ON)
position.
Move the throttle to FAST position.
Solution
694 - 002 -