Table of Contents
Advertisement
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
Lift up the front of the rail
1.
and unhook it (figure A).
2.
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
First insert the rail into the rear socket, press it to the back
1.
slightly (figure A),
and then hook it into the front socket (figure B).
2.
The rails only fit on the right or the left side. Ensure that, as
shown in figure B, levels 1 and 2 are below and levels 3, 4 and
5 are above. The pull-out rails must pull out forwards.
Folding down the grill element
You can fold down the grill element to clean the ceiling.
:
Risk of burns!
The oven must be cold.
Hold the grill element and pull the handle forwards until it
1.
clicks audibly in place (figure A).
Fold the grill element downwards (figure B).
2.
After cleaning, fold the grill element back up and hold it.
3.
Pull the handle downwards until it clicks audibly into place.
4.
18
Removing and installing the steam filter
A steam filter is located on the oven ceiling. This filters out
grease particles in the exhaust air and reduces odours. The
filter must occasionally be cleaned.
Removal
Using a 6 mm Allen key, turn the filter holder anti-clockwise
1.
and remove (figure A).
Remove both filter elements.
2.
You can use detergent to clean the filter holder and the thin
single-layer filter element or you can clean them in the
dishwasher cutlery basket. The thicker filter element should not
be cleaned. The coating may be damaged.
Installation
Place the single-layer filter element in the filter holder first
1.
followed by the double-layer filter element (figure B).
Insert the filter holder and, using the Allen key, turn it
2.
clockwise. Make sure that the filter holder is inserted as
shown in figure B. Only then can it be refitted securely.
Detaching and attaching the oven door
For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Advertisement
Table of Contents
