Still Recording - Sharp Internet ViewCam VN-EZ1U Operation Manual

Still Recording

You can record still images with operation similar to that of
film cameras. Before you start recording, see pages 14
through 20 to prepare your Digital Recorder.
Precaution:
• Do not try to record images with low battery power. It may
cause malfunctions.
1
Slide the POWER switch (1), set the Mode select
switch to STILL (2) and then rotate the lens body
toward CAMERA (3).
POWER MOVIE
1 2
2
Adjust the angle of the lens body to compose the
image on the LCD monitor.
3
STILL
STILL mode indicator
NORMAL NORMAL REM 18 REM 18
OCT.27.2‰‰‰ OCT.27.2‰‰‰
1‰:31 AM 1‰:31 AM
3
Press the Shutter button to record the image.
Notes:
• If the warning indicator "NOT INITIALIZED" appears, format
the SmartMedia card by the Digital Recorder (see page 64).
• The Digital Recorder automatically chooses the correct shutter
speed for the lighting conditions. Note that the slow shutter
speed set for the poor lighting may cause small image shakes.
And the image on the LCD monitor will be adversely affected.
• Using the Digital Recorder under fluorescent lights, mercury
lamps or sodium-vapour lamps causes flashs on the recorded
images. Sometimes those lightings affect tint of the images.
• The Still Recording mode is factory preset to NORMAL. If
you want to record still images in higher picture quality,
change the mode to FINE (see page 46).
Basic Operations
Remaining number
NORMAL REM 17
OCT.27.2‰‰‰
1‰:31 AM
26