Toro Flex-Force Power System 51824T Operator's Manual
60v max axial blower
Hide thumbs
Also See for Flex-Force Power System 51824T:
- Operator's manual (17 pages) ,
- Operator's manual (53 pages)
Related Manuals for Toro Flex-Force Power System 51824T
Summary of Contents for Toro Flex-Force Power System 51824T
- Page 1 Form No. 3441-947 Rev C Flex-Force Power System ™ MAX Axial Blower Model No. 51824—Serial No. 321000001 and Up Model No. 51824T—Serial No. 321000001 and Up *3441-947* Register at www.Toro.com. Original Instructions (EN)
- Page 2 Whenever you need service, genuine Toro parts, or For assistance, please see additional information, contact an Authorized Service www.Toro.com/support Dealer or Toro Customer Service and have the model for instructional videos and serial numbers of your product ready. Figure 1...
-
Page 3: Important Safety Instructions
O position. Use only the battery pack specified by Toro. Operate the appliance only in daylight or good Using other accessories and attachments may artificial light. increase the risk of injury and fire. - Page 4 Do not heat the battery pack above 68°C (154°F) or incinerate it. Replace the battery pack with a genuine Toro battery pack only; using another type of battery pack may cause a fire or explosion. Keep...
-
Page 5: Safety And Instructional Decals
Reserve al’usage domestique. Ne pas exposer à la pluie. Remiser à l'intérieur. À utiliser avec la batterie TORO FlexForce modèle : 88620. À utiliser avec le chargeur TORO FlexForce modèle : 88610. Voir manuel d'utilisation pour des options supplémentaires. - Page 6 decal137-9461 137-9461 1. Battery charge status decal140-8475 140-8475 decal144-3094 144-3094 1. Read the Operator’s 3. Keep away from open fire Manual. or flames. 1. The battery pack is 3. The battery pack is over 2. Call2Recycle® battery 4. Do not expose to rain. charging.
-
Page 7: Assembling The Blower
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Blower tube Assemble the blower. Important: The battery pack is not fully charged when you purchase it. Before using the tool for the first time, refer to Charging the Battery Pack (page 10). -
Page 8: Specifications
Specifications Operation Model 51824 WARNING Rated Voltage 60V DC maximum, 54 VDC nominal usage The blower can throw debris, possibly 88602, 88605, or 88610 Charger Type causing serious personal injury to you or (included with 51824) bystanders. Battery Type 88620 (included with 51824), •... - Page 9 Adjusting the Air Speed of the Blower To achieve maximum performance (air speed), press and hold the turbo boost button for the desired amount of time (Figure To adjust the air speed as you blow, use the variable-speed trigger (Figure To maintain the current air speed, engage the speed lock (Figure...
-
Page 10: Charging The Battery Pack
Slide the charger into the battery pack until it is fully seated (Figure 10). To remove the charger, slide the charger backward out of the battery. Refer to the following table to interpret the LED indicator light on the battery charger. Indicator Indicates light... - Page 11 If you are located outside of the US • Do not store the tool with the battery pack installed. and Canada, please contact your authorized Toro distributor. • Clean all foreign material from the product. • When not in use, store the tool, battery pack, and battery charger out of the reach of children.
-
Page 12: Troubleshooting
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The tool does not start. - Page 13 Notes:...
- Page 14 Notes:...
- Page 15 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.
- Page 17 Form No. 3441-942 Rev F Flex-Force Power System ™ 11in or 13in 60V MAX String Trimmer Model No. 51834—Serial No. 321000001 and Up Model No. 51834T—Serial No. 321000001 and Up *3441-942* Register at www.Toro.com. Original Instructions (EN)
- Page 18 This trimmer is intended to be used by residential Model No. homeowners to trim grass as needed outdoors. It is designed to use Toro Flex-Force lithium-ion battery Serial No. pack Models 88620 (provided with Model 51834), 88625, 88640, 88650, 88660, or 88675. These battery...
- Page 19 O position. Use only the battery pack specified by Toro. Using other accessories and attachments may Operate the appliance only in daylight or good increase the risk of injury and fire.
- Page 20 Do not heat the battery pack above 68°C (154°F) or incinerate it. Replace the battery pack with a genuine Toro battery pack only; using another type of battery pack may cause a fire or explosion. Keep...
- Page 21 Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal144-3098 decal139-5354 144-3098 139-5354 decal137-9461 137-9461 1. Battery charge status decal139-5361 139-5361 decal144-3094...
- Page 22 decal139-5210 139-5210 1. Warning—read the Operator’s Manual; stay away from moving parts; keep all guards in place; wear eye protection; do not operate in wet conditions. decal139-5346 139-5346 decal144-3096 144-3096...
- Page 23 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Allen wrench Unfold the handle. Auxiliary handle assembly Install the auxiliary handle. Guard Install the guard. Wire edge guard Install the edge guard. Important: The battery pack is not fully charged when you purchase it.
-
Page 24: Unfolding The Handle
Unfolding the Handle Parts needed for this procedure: Allen wrench Procedure Unfold the handle (A of Figure Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts together (B and C of Figure Note: The locking button clicks into the slotted hole when the shafts are secured (D of... -
Page 25: Installing The Auxiliary Handle
Installing the Auxiliary Handle Parts needed for this procedure: Auxiliary handle assembly Procedure Separate the auxiliary handle from the handle plate by removing the 2 screws (A of Figure Line up the auxiliary handle with auxiliary handle plate on the trimmer handle (B of Figure Secure the auxiliary handle to the handle plate with the 2 previously removed screws (C of Figure... -
Page 26: Installing The Guard
Installing the Guard Parts needed for this procedure: Guard Procedure Remove the 2 socket head screws, 2 washers, and 2 spacers from the trimmer base (A of Figure Align the guard onto the trimmer base (B of Figure Secure the guard onto the base of the trimmer with the 2 socket head screws, 2 washers, and 2 spacers previously removed (C of Figure g333607... -
Page 27: Specifications
Specifications Product Overview Model 51834/T Rated 60V DC maximum, 54 VDC nominal usage Voltage Charger 88602, 88605, or 88610 (included with 51834) Type Battery Type 88620 (included with 51834), 88625, 88640, 88650, 88660, or 88675 Appropriate Temperature Ranges Charge/store the battery pack 5°C (41°F) to 40°C (104°F)* Use the battery pack at -30°C (-22°F) to 49°C (120°F) -
Page 28: Starting The Trimmer
Operation Starting the Trimmer Make sure that the vents on the trimmer are clear of any dust and debris. g339793 Figure 11 1. Lockout trigger 2. Run trigger Shutting Off the Trimmer To shut off the trimmer, release both triggers. Whenever you are not using the trimmer or are transporting the trimmer to or from the work area, remove the battery pack. - Page 29 Charging the Battery Pack Refer to the following table to interpret the LED indicator light on the battery charger. Important: The battery pack is not fully charged Indicator Indicates when you purchase it. Before using the tool for light the first time, place the battery pack in the charger No battery pack inserted and charge it until the LED display indicates the battery pack is fully charged.
-
Page 30: Advancing The Line Manually
Advancing the Line Using the Bump Feed Run the tool at full throttle. Tap the bump button on the ground to advance the line. The line advances each time the bump button is tapped. Do not hold the bump button on the ground. -
Page 31: Operating Tips
Adjusting the Cutting Swath The trimmer comes from the factory with a cutting swath of 28 cm (11 inches) as shown in A of Figure 15. Refer to the following instructions to adjust the swath to 33 cm (13 inches) as shown in D of Figure Remove the swath blade from the guard by removing the 2 screws and 2 lock washers holding it in place (B of... -
Page 32: Maintenance
Maintenance Important: Do not use any other gauge or type of string, as this could damage the trimmer. After each use of the trimmer, complete the following: Bend the new string at the midpoint and insert Remove the battery from the trimmer. the bend into the starter slot in the center rim of Wipe the trimmer clean with a damp cloth. - Page 33 Figure 19 battery. If you are located outside of the US and Canada, please contact your authorized 1. String exit holes Toro distributor. Install the spool and cover assembly to the trimmer head, push until the cover tabs snap into place.
- Page 34 Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The tool does not start.
- Page 35 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.