Black & Decker Price Pfister Catalina 49 Series Manual page 4

11
11G
11F
11D
11E
11A
11B
11A
11 HOSE CONNECTION
From underneath sink, push the Center Connector (11A) onto receiving Tube (11B),
until unable to push any further. Pull down on the quick connect housing (11A). If the
housing and the Inner Collet (11C) separate slightly but do not pull off receiving Tube
(11B), the connection is secure.
Slide the End Connectors (11D) with arrow (11E) pointing up onto the Valve Bodies (11F).
Push the End Connectors (11D) all the way up until completely seated. Be careful not
to damage O-Rings (11G).
12
12C
12D
12A
12D
HOT
12E
12 WATER SUPPLY CONNECTIONS
First, thread Inlet Connectors (12A) into Water Supply Lines (12B). Then, insert Inlet
Connectors (12A) into Valve Bodies (12C). Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer's instructions when installing supply lines. Next, insert Clips (12D) into
Valve Body Holes (12E), to secure unit.
WARNING: Do not twist Inlet Connectors (12A) once installed!
11B
11G
11F
11D
11C
11A
12C
12D
12A
12B
12B
COLD
ENGLISH
DRAIN BODY INSTALLATION
13
13 POP-UP INSTALLATION
Install and adjust Pop-Up (13A) using separate instructions supplied with the Pop-Up
assembly.
14
14 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
FAUCET FUNCTIONS
15
HOT
OPEN
15 FAUCET FUNCTION
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise.
Note: Flush faucet before turning on valve (see step 16).
4
13A
COLD
OPEN