Changing The Comb Attachments; Cutting Hair - Silvercrest SHBS 3.7 C1 Operating Instructions Manual

• Figure B: to attach the attachments, put the lower flap of
the attachment 13, 3, 4, 12, 14 into the slot in the hair
and beard trimmer 5 and press the upper part of the attach-
ment against the hair and beard trimmer until it audibly locks
into place and sits firmly in position.

6.3 Changing the comb attachments

Pushing on
• To attach the comb attachments 2 + 1 carefully slide the ap-
propriate comb attachment over the hair or beard trimmer at-
tachment 13 / 14. Press the lower part of the comb
attachments 2 firmly until they lock into place.
Removing
• To remove the comb attachments 2 loosen the comb attach-
ment at its lower end and pull it off the hair and beard trim-
mer 5.
• Slide the comb attachment 1 for the beard trimmer attach-
ment 14 upwards from the hair and beard trimmer 5.

6.4 Cutting hair

Hair trimmer attachment
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending on the cutting angle.
• Place a sheet or cape around throat and neck to prevent cut-
off hair from dropping into the collar.
• Comb the hair well.
13
13
GB