2.5
Power Saving Configuration
The Power Saving Configuration parameters are configurable only if
your system supports the power-management feature.
The following screen shows the Power Saving Configuration
parameters and their default settings:
Power Saving Configuration
Power Management Mode ................[Enabled ]
IDE Hard Disk Standby Timer .......[ 15] Minute(s)
System Standby Timer ..............[ 15] Minute(s)
System Suspend Timer ..............[ 15] Minute(s)
Monitored Activities
*IRQ 0........[Disabled]
*IRQ 1........[Enabled ]
IRQ 3........[Disabled]
IRQ 4........[Disabled]
IRQ 5........[Disabled]
*IRQ 6........[Enabled ]
IRQ 7........[Disabled]
¯ = Move Highlight Bar,
PgDn/PgUp = Move Screen,
2.5.1
Power Management Mode
This parameter allows you to reduce power consumption. When this
parameter is set to
Enabled
system
timers.
Setting
power-management feature and all the timers.
2-16
IRQ 8 .......[Disabled]
IRQ 9........[Disabled]
IRQ 10.......[Disabled]
IRQ 11.......[Disabled]
IRQ 12.......[Enabled ]
*IRQ 13.......[Enabled ]
*IRQ 14.......[Enabled ]
IRQ 15.......[Disabled]
® ¬ = Change Setting
F1 = Help,
Esc
, you can configure the IDE hard disk and
Disabled
to
Page 1/1
=
Exit
deactivates
the
User's Guide